1972 Chevrolet Blazer

Convertible

V8

Manual

Clear

This is a project. I've owned this since 1992, drove it for a few years and it has sat since then. This has a combination of good body panels and panels that need body work. Most damaged panels should be visible in the pictures. The rockers below both doors need replaced as they have heavy rust. I already purchased the drivers side rocker from a Chevrolet dealership but have never installed it. This has a 6" suspension lift on it that I purchased and installed. The front is a suspension lift and the rear has blocks. It also has a raised steering arm. It will have the wheels and tires that you can see in the pictures. None of the tires are guaranteed to hold air and it looks like most of them don't. I had 35" BFG's on it but they do not come with the Blazer. A small portion of each rear fender was trimmed to allow for articulation of the rear tires while rock crawling. This came with a 350 originally but there is not an engine in it now and it won't come with one. The transmission is the stock factory 4-speed and it works great along with the transfer case. Axles are stock and the front has a broken u-joint (maybe two) and no driveshaft. The rear works fine and I cannot remember if it has a posi-trac or not. The interior is stock except for the plaid carpet. All of the gauges work. No it does not have a factory tachometer. A light duty skid plate was built and is installed for the fuel tank. Seats are stock and in good condition. The top in in good condition and easily removed. The tail gate has a large dent that might be difficult to see in the pictures. Ask questions and I'll do my best to get them answered. Tires and wheels can be installed for shipping for whatever some used tires would cost at a local tire shop. The buyer would have to pay for these and we would install them on the Blazer.I can help load this on a truck or trailer but all shipping is the responsibility of the buyer. This does not have a reserve. Good Luck