1972 Honda CB

Clear

1972 CB500k Cafe Racer CLEAN AND CLEAR TITLE IN HAND!!!This is a one of a kind MUST HAVE BIKE! This bike has been restored and built from the ground up. Everything on this bike is either brand new or reconditioned and rebuilt like brand new. Below you will see the laundry list of new parts and what all has been done to this beautiful bike. New Part(s) list: - Brand new wheels powder coated victory red with new chrome spokes - Brand new Pirelli street demon tires with zero miles on them! - Clip-on Cafe racer style handle bars - New front and back sprockets with red chain - 4 into 1 exhaust (Yoshimura style exhaust) - Custom fabricated seat - New chrome gas cap - New stainless steel allen head engine cover bolt kit - New head light - New chrome headlight brackets - All brand new electrical components hidden under the seat - New ignition switch - New Combo Voltage Regulator Rectifier - New 8 cell Anti-gravity battery - New starter relay solenoid - New red NOS shocks - New master cylinder - New brake lines - New electric start switches on the handle bars (black and red to match the bike's color scheme) - New handle throttle - New upper forks including new seals and o-rings. - New front fork tube bolt caps & o-rings. - New All Balls steering Stem Bearing kit - New air pods - New brake light - New spark plugs and new red spark plug wiring installed to match the bike's color scheme. - New gas tank petcock with new seals - New red gas lines- New oil filter bolt- New oil Filter- New chrome valve Tappet covers Restored/custom fabricated parts: - Lower forks cleaned and powder coated charcoal grey- Front fork's internals have been cleaned, reconditioned and fresh new oil added. - Frame has been professionally customized and fabricated. - Frame also powder coated black - Original tank that has been cleaned and sealed on the inside and custom cafe racer knee dents added to the outside, for that authentic cafe racer style look. - Custom battery tray and seat pan fabricated under the seat. - Seat has been fabricated so it locks to the back of the seat pan from underneath the taillight. (fits like a glove.) - Front and back wheel hubs polished out to perfection. - Front Brake caliper is paint red with heat resistant paint. About the Engine and Motor: - Brand new gaskets - Engine's top end has been rebuilt with new gaskets and polished pistons. - All internals have been cleaned and reconditioned - All Engine covers have been polished out to perfection. Other than the top engine cover, which has been powder coated charcoal grey. - External of Engine has been cleaned, reconditioned and repainted to factory Honda color. - New allen head stainless steel bolts have been installed. What the bike needs: I have put over $9,000 into this build and unfortunately I have run out of time and need my money back out of it before I am able to finish the bike and enjoy it. It is very close to being done. The bike turns over and runs great!!!! It does not currently drive right now because the clutch cable is not hooked up, the front brake needs to be hooked up and bled, carbs need to be cleaned, and the brake light needs to be wired. Other than that a nice pair of grips and that's all it needs. I hate to see it go because this was/is my dream bike but unfortunately I have to let it go. My loss is your gain. If you would like to make an offer on the bike I am open to all offers please just send me a message.