1965 Shelby Cobra

Kit Project Other

8 - Cyl.

Manual

Kit Car

Gasoline

1965 Shelby Cobra kit car, project Over 40K invested so far, asking $21,500.00 Kit is RU Car Crafters (RUCC) It's a full frame car, independent rear suspension (IRS) Rear end is an 8.8 aluminum housing, 307 gears, posi-lock. Engine is a 460, Transmission is a Richmond 5sp. Flaming River rack and pinion steering. Tilton hydraulic brake and clutch pedal assembly. Over 40K invested so far. The kit cost 18K with no drive train. Motor and trans details -- 460 engine, Eagle I beam rods, Complete Edlebrock performer package, aluminum heads, intake, carb, water pump, fuel pump, Keith Black pistons - Canton oil pan, All balanced and Blueprinted, Mike Forte clutch setup with Lakewood scatter shield bell housing, Richmond 5 Speed. Mallory distributor, MSD ignition box and coil. Two electric cooling fan kits--one for front and one to pull. Oil filter relocation kit, engine oil cooler, Exhaust kit, Drive shaft, Seats, seat belts, steering wheel, gauge kit with electronic speedo, Halon Fire extinguisher kit, wiper kit, heater kit, wiring harness kit, Windshield kit, steering wheel, disk brake kit -- front and rear, have front and rear lighting, mirrors, Cobra badging, fuel filler, brake lines, single wire chrome alternator, gear reduction starter, carpet kit. These parts are all NEW! Frame and suspension is setup and painted, Motor and trans mounting completed, brakes are all setup and mounted, seats are all setup with mounting, brake and clutch reservoirs are setup and mounted, Lokar e-brake setup and mounted. RECENT completion on engine oil cooler, cooling fans, door latch frame supports...... Need to, run brake and fuel lines, finish cooling system, mount remote engine oil cooler parts, wiring and dash assembly and paint. I am working on this weekly, fitting, fabricating, and mounting parts. Have receipts. summitsp@colomail.com 970-290-2102