1970 Dodge Charger

Clear

This is a No Reserve Auction, Bid to own ! This auction is for the customized 1970 Charger with Ray Barton KB528 Blown Hemi (never made it to the road) The body was stripped and interior and everything was powder coated, (by Streetwerkz Columbus, Ohio) exterior panels are primed black for body and paint work, hood needs to be primed, still has original paint. The car is a rolling chassis ( all welds are complete) with the front fenders and all tub work and loose panels fuel lines and misc separately stored and have been powder coated. Misc parts both from the original car and the custom build. Way too much to list, I have all receipts and invoices for work performed (Alec Carpenter, Columbus, Ohio "ARK Hot Rods") over a ten year period. Hemi was always stored in a climate controlled area. I have all Ray Barton receipts and Dyno Test results when I picked up the engine. Keith Black Aluminum Engine averaged 1000hp and approx 850 ft/lbs/TQ at about 5% boost, at 6500 rpm I was told by Barton it should have no problem making a few hundred more HP if needed. Brakes, pedals, steering wheel,steering column, dash, custom headers, 4" exhaust Borla mufflers custom exhaust tips, wheelie bar, etc. The car was basically all assembled and then disassembled for powder coating and primer, once done, stored and recent health issues caused change of priorities. There is a complete wiring harness with fuse panel, fuel tank and fuel pump with all stainless lines and Fast Fuel Injection components. The motor from Barton was $40,000 back in 2006, and other than watching it run on the dyno, it hasn't been run since. There was never a transmission or rear gear that was matched for this car yet. (Special Bell Housing was purchased) Chrome Moly round tube, I cannot remember if the frame has been certified yet or not.All framework is welded. ** I didn't personally do the work, so I may not have all of the answers, but I can check ** Upon buyer inspection, if the vehicle is not satisfactory, not a problem. Buyer is responsible for pickup I added some photos of the car prior to the customization, the car was in beautiful shape with hopes to eliminating additional body work at the end of the project. (the car was sitting in a dealerships showroom for some 16 years prior to me purchasing it. I added a picture of the custom 4" exhaust as it is currently stored. Buyer is to pay for vehicle in full within 14 days of auction close or the car will be offered back up for sale or to the next bidder.