1973 Ford Mustang

Convertible

351 Cleveland four-barrel Holley Modified w/cam

Automatic

3F03H236208

Clear

Gasoline

This is a 1973 Mustang project car that I purchased in 1996 and will never complete. It is time for someone else to complete the project. You will be purchasing the car as well as all the additional parts listed that I have acquired over the years. This is a running car. It has been garaged since I owned it. It drives fine and has been registered the entire time I have owned it. It has a clear North Carolina title. The car was purchased in Massachusetts in 1996. It does have some rust but is a restorable vehicle. Many or most of the body parts needed are included with the car. The car is equipped with the original 351 Cleveland engine that was rebuilt before I purchased it and modified with a cam and four-barrel intake and Holley carburetor. Headers were also installed. Also when the engine was rebuilt a MS ignition system with an Accel Coil was installed. This would be a good project to work on over the winter and have it ready for spring/summer shows or just fun driving. Since I have owned the car I have had the transmission and carburetor rebuilt. Installed a new gas tank, starter and U-joints, New brakes front and rear including calipers, drums and hoses. Replaced the fuel pump, alternator and voltage regulator. The following is a list of most of the parts included with the sale of the Mustang. You will need a truck to carry the parts. They should fit into a pick up. Rear quarter panels: left and right Front floor pans: left and right Replacement frame rails Inner rear fender NOS Front spoiler Black padded dash NOS Replacement rear tail light body panel NOS Replacement black Grille NOS Original Exhaust manifolds All new exhaust system parts to fit original manifolds including mufflers Center console Rear spoiler New four piece fender trim NOS Replacement right front fender Complete replacement dash with Tachometer Air conditioning parts including behind dash to equip this car with AC Original wheel rims (3) Original hub caps (4) Original intake manifold with carburetor and air cleaner Original Distributor Original valve covers Various other misc. parts This is a cash sale only, with no reserve. . The parts alone should be worth at least $1500.00. The car is located in Flat Rock, N.C. and the buyer is responsible for picking up the car and parts. I will not ship, but will help load. Any questions, please Email me or call me at (828) 693-9784. I reserve the right to end the auction early for local purchases. Mal Ludden.