Detail Info for: Ford : Mustang Base Hardtop 2-Door 1968 Ford Mustang

Transaction Info
Sold On:
07/12/2014
Price:
$ 10700.00
Condition:
Mileage:
7000
Location:
Portland, Oregon, 97206
Seller Type:
Private Seller
Vehicle Specification
Year Make Model:
1968 Ford Mustang
Submodel Body Type:
Hardtop
Engine:
351W
Transmission:
TCI C4
VIN:
8R01J163163
Vehicle Title:
Clear
Drive Train:
Fuel Type:
GAS
Standard Equipment:
Optional Equipment:
Vehicle Detail
I have had this since 2005. I installed a 351W. 1971 block. World SR heads. KB Flat tops 1/16 rings, ARP rod, crank, head bolts, Summit perf. damper, TCI flexplate. Pistons, rods, crank, balancer, flex plate were all balanced. Summit dual plane stage 2 manifold, MSD ignition box, mech msd billet distributor. Comp cam big mutha thumpr hyd flat tappet, 3500 summit stall. Has holley 650 DP, Richmond gear kit 3.55 & mini spool. Carter mech. 7 psi 160gph fuel pump. Vacuum canister. Also have a comp H268XE/ 2200 stall to go with car. I installed the Comp cam just a few months ago. I changed out the head gaskets, changed freeze plugs and installed new Isky springs and positive stop valve seals, 3500 stall. I really like the top end on this car. The cam is one half degree retarded @ installed. I changed from a 268XE Comp. This engine is much faster and a lot higher rpm power. I find it myself very nice. But I like tight lobe cams. About 7000 miles on engine. Actual mileage of car is unknown. Have not finished exhaust. Currently 2.5" flow masters that dump in front of rear end. Have not finished the transmission lines. They run through a cooler but mixed from 3/8 hard lines to rubber transmission hose. Hedman headers 1 7/8" / 3" Ball type collector. New front suspension, complete kit from mustangs unlimited. New big block springs, front end alignment. Newer rear leaf springs, brakes, bearings. 15x7 & 15 x 4" Weld Draglite wheels. Front tires 90%, Rears are brand new. Car is very solid. (See Pictures) Few rust areas just behind rear window at trunk area and just under heater core floor plate, about 6" area. Other than that the car is solid. The power steering is not currently hooked up. Have everything for it. Also have the original A/C unit, also not hooked up, have the brackets, etc. The drivers seat is starting to tear on seat portion (see picture). The drivers window crank assembly is getting tired but works. So please contact for further information if needed, pictures/information.