1998 Chevrolet Tahoe

Sport Utility

5.7L 350Cu. In. V8 GAS OHV Naturally Aspirated

Manual

3GNEK18R7WG147758

Clear

GAS

I am offering for sale this 1998 Chevrolet Tahoe, but it is far from stock. Here are the details- 1998 Chevy Tahoe 2 door, 4bt, Nv4500, Dana 44 front axle, sterling 10.25 rear with 3.55 gears, and limited slip. 4bt runs great. VE pump, HX35 turbo,New Rod and main bearings about 2000 miles ago, cylinders were clean with crosshatch still. I don't know how many miles were on the motor. Uses 1st gen Dodge Cummins mounts, and a Chevy bell housing adapter. GM granny low Nv4500 with new clutch, pressure plate and throwout bearing 2000 miles ago. New Process 241C transfer case. Both transmission and transfer case were from a 3/4 ton truck. Dana 44 front axle from a '77 F-150. Solid axle tubes all the way through, not cast. GM 8 lug spindles, New ball joints, u joints, axle seals, and bearings through out, new brake calipers, pads and rotors, all new poly bushings. Uses rancho lift springs for the F150. All new tie rod ends on crossover steering with high angle drag link. New Mile Marker steel hubs. Sterling 10.25 rear, new axle seals, brakes, and e brake cables. Mounts relocated to use stock Tahoe springs with a small block and add a leaf. It is a running and driving truck with a few things that need to be finished, but I just don't have the time. Here they are- Radiator hoses need to be taken off, and matched up with something so they are one piece. Needs to have a power steering line made for the pressure side. Right now it is spliced and it drips. Needs to have the A/C mounted on the engine and lines routed. Emergency Brake cable needs to be connected to the Ford cables. It needs a front end alignment. I just measured it and got it close. Originally it was a 350, automatic, 4x4, out of Texas, so it is basically rust free other than where the paint faded, and the lower part of the passengers side front fender. The clutch safety switch was installed and works like factory, as does the ignition switch, which was switched out to the manual transmission style. The straight axle and lift is equal to about a 4-5" lift. It clears 285's with no problem. Everything inside works like factory, with the exception of the Tach. Converted to composite beam headlights and grille, with new glass headlights. I hate to sell it, but I could use the money to finish some more important projects. I am sure I am forgetting things and will add them as I remember. If there is any thing specific you would like to know, feel free to ask. I have a clean title in my name ready to go. If you have any questions, feel free to ask, and Thank You for looking. I have this listed for sale locally, and reserve the right to end the auction at any time. I also reserve the right to reject any bid from any buyer at any time, and change any information at any time. This is a modified vehicle, and is being sold AS-IS. Key words- Cummins, NV4500, 4bt, conversion, Cummins conversion, Cummins swap, Chevy Cummins, 6bt.