1967 Ford Mustang

Fastback -

8 - Cyl.

-

7t02c282841

Gasoline

FORD MUSTANG FASTBACK 1967 ELEANOR PROJECT *****PLEASE READ ENTIRE DESCRIPTION, THIS WILL AVOID ANY CONFUSION LATER.***** THIS IS THE THIRD TIME I AM LISTING THIS CAR...IF YOUR NOT GOING TO PAY FOR IT, DON'T BID ON IT. EXCELLANT condition. Here we have a 1967 Mustang Fastback...Eleanor Project. Car is taken all the way down right now and in the process of being restored. Car comes with complete interior, along with the fold down rear seat and original 289 block/heads. All parts I have new are from national parts depot and are as follows: Radiator support( new version with front crossmember isntalled, thicker 18 ga metal than standard support) $129.95 Inner fender/shock tower (both sides) $649.50 each Front frame extension(both sides) $157.95 each Side outer cowl panels(both sides) $49.95 each Torque boxes(both sides) $43.50 each Toe boards(both sides) $34.50 each Floor pans(both sides) $60.75 each Drip rails(both sides) $126.95 each Roof skin $381.95 Total $2714.20 in parts I also have a built up Ford big block 460 that I was going to throw in the car. Just started the project but moving so I must sell, need it gone asap. It is listed on other sites... Won't disappoint. Car is currently not on all 4's. Within 24 hours of the auction close, a $500 deposit is due via paypal, the remainder due at pick-up (NO CHECK or CC). Vehicle is pick-up only, and must be done with 7 days of close of auction. You will be picking up in Howell, Michigan 48843. Vehicle will need to be trailered. Exact address to the winner only. On May-31-11 at 18:08:22 PDT, seller added the following information: Hers is a little info on the 460... Double A block Bored to 472 High rise intake-for motor sport D0VEC heads-port and polished Thick web 2 bolt Comp cams Roller motor Aluminum engine hard mount Deep sump oil pump and pan-Moser MSD distributor billet-has harness ready for MSD box TBI harmonic balancer Aluminum plate to bolt to Chevy or Ford tranny Motor was made to put in Mustang II front end but can modify for any