Detail Info for: Ford : Mustang GT 1990 mustang gt

Transaction Info
Sold On:
04/12/2015
Price:
$ 5600.00
Condition:
Mileage:
51
Location:
Grass Lake, Michigan, 49240
Seller Type:
Private Seller
Vehicle Specification
Year Make Model:
1990 Ford Mustang
Submodel Body Type:
GT Coupe
Engine:
5.0 EFI High Performance
Transmission:
Manual
VIN:
1FACP42EXLF160113
Vehicle Title:
Clear
Drive Train:
Fuel Type:
Gasoline
Standard Equipment:
Optional Equipment:
Vehicle Detail
Very clean! good torque boxes and floors. sanded and undercoated floor and trunk. New Quad link rear suspension, rebuilt and up graded rear end to 4.10 gear w 28 spline axles and new bearings/races. New driveshaft U joints, rebuilt T5, new synchronizers and bearings/races, New F1 500HP racing Clutch, Engine bay sandblasted and painted White. Engine is a .302 block, bored .40 over, new crank, new rods, Keith Black flat top pistons, gapless rings, GT40 ported and polished heads with Ferrea .190 intake and .160 exhaust valves. Dual springs, Comp cam .520 lift 282/288 dur., Comp cam 3/8' 1.6 roller rockers, trick flow roller lifters, Trick flow track heat upper and lower intake manifold, 30lb bosch fuel injectors, BBK 75mm cold air intake with BBK mass air flow meter, BBK off road H-pipe, Moates performance tune chip, A/C still on Vehicle. Ford Racing rocker covers, MSD Ignition and Module. Very good interior. slight tear on drivers seat bottom where backside of left knee rests, door skins good, roof liner good and tight, dash good no cracks, backseats and package tray area good. power windows good, power locks, windshield has some cracks and paint around the edges from a new paint job. comes off with a razor just haven't done it yet. Rear windows and hatch glass good. Needs - I have a new set of window runs and seals to be installed, I have mid-door moldings to be installed. black pin stripe for moldings needs to be attached, new black "Mustang" for side moldings and rear valance needs to be installed, 5.0 badges and Ford badges need to be affixed, Radio needs to be installed. Needs outer windshield molding, needs outer hatch window molding, I have a Kenwood CD player with a Pioneer 200w sub and some boston accostic 6x9's that needs to be installed only 51 miles since rebuild. Motor, trans and rear end still needs to be broken in. picture with the lights on shows right front outer blinker bulb out. I replaced the bulb and it is working now. I will be donating 2% of sale price through Paypal to the Iraq and Afganistan soldiers care fund and 3% to Disabled Veterans of America God Bless our Troops! Thank you for looking!