1970 Ford Bronco

302 V8

U15GLJ89567

Clear

4th AZ owner selling 1970 Ford Bronco Station Wagon Uncut and has NO rust other than minimal surface rust on the under body and frame. (Never been out of AZ, First registered/ 4/70) Fantastic for full restoration, 4X4 trail driving or daily driver. All running gear has been completely gone over in the last 20,000 miles 302 (original engine,154 thou miles, not running, just developed a loud knock last month) New Venture 4500 Transmission (5 speed floor mount manual Dodge transmission with a low granny gear and an overdrive gear) professionally installed 12,000 miles ago along with new clutch. Drive lines where modified to accommodate the new setup. Dana 20 Transfer case with T shift pattern that safely operates in low range 2 wheel drive, rebuilt 12,000 miles ago Ramsey 8000 pound winch mounted on Proto Fab pre runner front bumper Proto Fab rear bumper with tire carrier and gas can/ cooler carrier Rear 9 inch Differential has ARB air locker system and 31 splne heavy duty axles Front Axle is Dana 30 with Toms Bronco Conversion Kit for Disk Brakes using Chevrolet Disk Brakes. Body has uncut rear wheel wells and is very clean with a little touch up needed on the engine hood where cracks were repaired. Body has a 2 inch lift for extra clearance Still has the original radio which works, but a short in the antenna cable system gives it lots of static. My wife says that it only plays songs from the 1970's anyway. Tub has been rhino lined for insulation and sound proofing Four point Roll Cage Original seats but have been recovered but driver’s seat will need to be recovered again Door Hinges are Stainless Steel Quick Remove style for instant removal of doors Oversize 4 core Radiator Dual Exhaust system Mean Green High Output AlternatorDual Battery system and battery isolation wiring; winch will operate on both batteries with ignition off 23 gallon extra large rear fuel tank and good original front tank Powdercoated 16 inch Ford 1971 Rims with Good Rubber Includes many extras including: extra 302 engine (not running) many carb and ignition parts and Bearings, C-4 automatic Transmission and 9 inch rear axle with large bearings from 71 ford PU, James Duff front axle Dual shock mounts and Dual rear shock mounts, Drum Brake parts, Deep Drop receiver hitch with 2 inch ball, many original maintenance records, Ford shop repair manuals for 1971 Ford Trucks and Broncos, and Chilton’s Bronco Guide, weather stripping for doors. When engine went south and developed a knock, I realized my interests have changed and I need to sell this project and all parts that go with it.