1967 Chevrolet Camaro

Coupe

421 inch

Automatic

124377N162374

Clear

Gasoline

I've owned this car since 1995 and hate to sell it. Beautiful paint and body. This car is all steel and everything works as it should. The headlight doors open and close correctly, the interior lights work and even the backup lights operate. The chassis was built by two very well known shops, Ken Keir RaceCars mini tubbed the car and built the moly roll cage. They also did the ladder bar setup and narrowed the 12 bolt rear, adding moly axle tubes and using Mark Williams parts inside. Wolford Bros. Chassis setup the chassis, wired and did the plumbing. The engine is 421 cubic inches and has a Dart Little M block with billet caps, scat steel crank, J.E. pistons and Manley rods. The compression is 15-1. 18 degree G.M. Heads with Del West Titanium valves, T-D shaft rockers and Comp Cams springs and Titanium retainers. It has a cast manifold and a Pro Systems modded 4150 carb. It also has a Cam Motion solid roller cam with Comp lifters. The trans is a ATI 400 with matching ATI convertor. The wheels are Monocoque on the rear and fronts are Weld Magnum or Alumistar, your choice. Lemons coated headers with 3 1/2" exhaust exit into Spintech mufflers. It has a Product Engineering race combo fuel pump and filter. As for the mileage in the listing, I am truly speculating as there is no speedometer cables in the car. There is way too much to list here but the chassis was certified to 8:50 but ran out. I use this car as a street cruiser only, not as a race car. It is in beautiful shape and is the center of attention anywhere it goes. Please contact me directly with any questions you may have. This car is truly top notch and the pictures say it all!I will not consider any trades and shipping is the buyer's responsibility. Payment must be received within 7 days of purchase. Thanks for looking!