1985 Honda ATC 200S

JH3TB053XFK423971

Not Available

READ CAREFULLY, LOCAL PICKUP ONLY!!! UPDATE: The new rear bearings are installed, found that the chain link/lock must have fallen off, right rear tire lost air today too for what ever reason?!, rear brake drum needs to be cleaned well before rear pads go in, Factory rear plastic cracks are all heat stapled from the underside to prevent the cracks from spreading more, might need a new plug or it fouled out... it started but later on I couldn't get it started again. probably something simple I just don't feel like messing with it. Up for auction is a 1985 Honda ATC 200S 3 wheeler. I received this 3 wheeler as a running project. Over time I purchased many parts, swapped parts and started to fix it up. The 3 wheeler was running when I got it, still runs well. Overall this machine is fairly clean. There are a couple obvious things that need attention like the dents in the tank (that is mounted currently), the factory rear plastic has some cracks but nothing that cant be repaired with time and effort. The decompression cable needs to be connected but I have not taken the starter recoil apart to check and see if the proper parts are in there or if they are in good shape if they are. That makes starting it tough at times as far as pulling. I have all the parts for the brakes but the brakes need attention whether its the lines or what not. There were no brake perches when I got the vehicle. The tires that are currently on it are all in good condition, rims do not appear to be bent as far as wobbling but there are a couple small bends on the edges (common). The front headlight trim bezel, casing and mounting brackets were refinished in automotive paint (Casing was cracked where the mounting bolts go in but all repaired) The gears shift well from what I could tell. Overall this machine is in good condition but does need some attention in some areas. Here is a list of parts I purchased: New front and back EBC grooved brake pads, comes with springs (not installed yet) New front Gas tank grommets (installed) Used front fender with a minor crack repair (using heat staples and epoxy) Used Decompression cable (Installed) New rear axle adjustment screw Used front sprocket cover (repainted black) New custom seat cover (started to install but my stapler isn't strong enough, needs finishing) 2 used brake perches (installed in good condition) New All Balls rear axle bearings (installed) Used factory rear fender assembly with trunk (installed currently) Used upper engine mounting bolt (not installed yet) Gas cap with on off switch (repainted) New tire tube for left rear wheel, slow leak in the currently installed one (new not installed yet) Mudflap... was taken off but reinstalled (not in pic) New front and rear EBC grooved brake pads ( not installed yet) All paint work was done with automotive dupont paint, not rattle cans. The paint code used was GM, paint code 9260 which is a red color on the newer Camaros. If this doesn't sell I will be repairing the tank and rear fender and refinishing them also. I described everything the best of my knowledge. If you have questions please ask before bidding! LOCAL PICKUP ONLY! I accept paypal or cash in hand. I do not have a title nor did it come with one. I WILL write out a bill of sale which will be signed by myself and the buyer so the machine can be registered in the buyers name!