1966 Plymouth belvedere

belvedere2 2 dr

383----------400-408

Manual

rp23gg1200923

Clear

Gasoline

super stock spring with dana 60 354 hemi 18 spline 4 speed 1972 400 block with 383 forged rods and crank .040 over piston flat top all balance closed chamber heads new valves and harden seat -509 cam shaft 650 double pumper tm6 single plane intake many new parts body work was started never finish from prior owner hardship deal ----- needs body work completed and paint ------interior 48 years old door panels front have speaker hole and rear usable seats need recover and front buckets need lower foam- head liner has critter hole by visors from winter home ---visors need recover stiching falling apart 48 years old engine compartment will be straighten up they were my test gauge while running motor wire will be trim and straighten this week -----auction will run full term has the big drum brakes front sway bar factory black on 4speed car just so hard to find now days if this was finish nice 20k could be the value compression think 10 to 1 cam degree at 108 stock type rocker arms and push rods melling hv pump with magnum oil pan and windage tray receipts for trans overhaul and shifter was rebuilt lower part buy hurst dc distributor and ignitionOn Mar-31-14 at 14:29:24 PDT, seller added the following information: the car is in gray type primer door pinch welds clean seam sealer still there all door handles there---- locks---- it's just not on due to prep for paint job-- doors open close nice all chrome trim for side of car in nice shape and clips are in same cans I got them in windows nice no cracks weather strip around run channel still there look good will need the felt strips for out side of glass as they are normal to remove for good paint job this stuff is available on line to buy -------hoses new all mounts new arp head bolts new water pump the radiator was a recore -------11 inch clutch the headers ok I sand blasted them and exhaust ok I think 3 inch system is the way to go -----------but its up to you this will get you down the road for a while--------head liner is livable not sagging down just the small holes by visors------this is realy a nice car that needs a mopar person to give it a home great father and son project or a person of intrest---------------I have 3 other cars and just no more time just looking narrow down less cars more time hope this answer any ???? ask if you have any thanks again for looking at this b body mopar