1987 Honda 250x

??????

Not Available

Honda TRX250X Foretrax I bought this a few months ago as a project I paid $700. The bike ran but had been sitting. I cleaned the carburetor and it ran good and idled fine. At this point I could not ride it yet because the rear bearings were shot. I removed the exhaust and painted it with high heat flat black header paint. The NEW rear bearing carrier came so I installed it and went to take a ride. The engine still will not rev over around 1500 RPM ???? Someone told me it could be the ignition box? One front tire leaks down in a day or two. Plastic in usable condition, have new rear brake pads not installed. Runs and drives. This is the third time listing this, with two buyers not following through. First was a "0" feedback the second was a "14" Please don't bid unless your willing to follow through. . NO "0" Feedback bidders unless I talk to you first. I will cancel your bid if you don't call first Call me 331-645-0585 Thanks for looking & Good Luck On Dec-19-12 at 21:11:08 PST, seller added the following information: Added a few more photos. I have had a lot of people asking questions. The plastic is not attached to the bike, I removed it to get to the carb. all mounting screws and bracket are there. Photos not the best, is is deep back in the garage and hard to get to. It is kick start only.Runs .Don't know whats actually wrong with it.(timing?, Carb?, ign. modual?)frame is painted in assembly so bolt , nuts ect... are all painted on the front end.