1973 Ford Mustang

Mach 1 Fastback

400M Police Interceptor

FMX AUTOMATIC

3F05HI22594

Clear

Gasoline

New:K&N Air FilterEdelbrock 600CFM Performer Series CarburatorEdelbrock Performer Series Intake ManifoldEdelbrock Victor Series Polished WaterpumpPowerMaster 60AMP Chrome Alternator (Wired by Meridian Automotive)Motorcraft Voltage Regulator (Wired by Meridian Automotive)Electric Fan, thermostatic switch, and circuit breaker (Installed and Wired by Meridian Automotive)RadiatorMSD Ignition: -Pro-Billet Distributor -Spark Plug and Coil Wires- Blaster 2 Coil -6AL Box with MountCompetition Cam Magnum Double Roller Timing SetSteering Column, Coupler, and Key Cylinder (Installed and wired by Les at Super Tune)Hurst V-Matic 2 Shifter (modified, installed, and wired by Meridian Automotive)Master Cylinder and Lines Trunk Battery (700+CC)Upper Ball JointsLower Ball JointsControl ArmsPitman ArmVertical RodsFord 9" Rear End was serviced early 2012Rotors and PadsExhaust is straight back with Cherry Bomb Glass PacksFuel Sending Unit The motor was tuned and adjusted early 2012The Transmission was serviced and adjusted around the same timeAll Threads were sealed with JEGS Sealant All Gaskets were replaced with parts and sealed with Edelbrock GasgainchAll Hoses were replacedAll Fluids were flushed and replaced with High Quality fluids including gas tank as well There is a small transmission leak from Front driveshaft seal ($15) and the transmission pan gasket (I have a spare) due to a bad transmission mount (less than $50)Tires need replaced.I have an extra set of wheels that are 16.5" x 8" that go with the carThe tires on it now are 215/60r/15 are on the front and on back are 295/50r/15 Interior needs minor work: -Glove Box ($100) -Door panels ($100-$150) -Headliner ($100) -There is a hole that was cut out by the previous owner for a sound system that needs replaced located between the rear seat and trunk (trunk roof) it's a flat piece of steel scrap that needs welded in. (~$250) -Carpet was replaced right before my purchase -Seats are in good condition Exterior needs a little as well: -Hood has a hole and large bondo spot (New hoods are $250-$300)-Fender has a large dent that can't be fixed (New fender is $200-$250)-Maaco will sand down to bare metal pop out any dents , replace the metal that is infected with rust bubbles/cancer spots, and primer and paint it all for $1,500. I also have a ton of parts and accessories that weren't used/put on that will also be sold with the car. The rest of the work will cost less than $3,000 to make it back to a decent/nice conditionI have roughly $15,000 into the car and can't afford to put any more in it because I am going to college this next fall.I'm asking $6500 Or Best OFFER. After the few things I listed are done the car has the potential to sell for roughly $17,000+