1991 Pontiac Firebird

Other

8 - Cyl.

Automatic

1g2fs23t2ml215247

Clear

Gasoline

For sale is a 1991 firebird that I have been restoring for the last year I unfortunatly am getting a divorce and need to sell it as I dont know where I will be soon and really need the money. The car is in good shape there is some minor rust spots on the body, the frame was rusted through i had to fix it to bolt in the trans. the undercarrage will need to be undercoated as it is starting to have rust spots, it has wide tires/rims on back skinny on front all aluminum race rims it will however need new tires at some point (I was just going to roast them off) I do have the driveshaft for it but it will need to be cut down to fit the car and also have the exhaust (almost brand new) tougher springs for the rear and a b&m ratchet shift for it. also the drivers door will need a new latch. The motor is a 350 2 bolt bored to a 358 I had pakes in janesville do all of the machining and I built the motor as you can see in the pics, it has federal mogel pistons .40 over, shaved 53cc heads a lunati mild street strip cam, edlebrock intake,650cfm carb, and air cleaner, it has lots of chrome and it RUNS!!! the motor is bolted to a stock used B.O.P TH350 trans This is a good deal for someone to have most of the expensive stuff done i have about 4500 (parts/labor) into it on a project car, I wish I could finish it but my loss is your gain!! On Jan-02-12 at 09:20:04 PST, seller added the following information: For sale is a 1991 firebird that I have been restoring for the last year I unfortunatly am getting a divorce and need to sell it as I dont know where I will be soon and really need the money. The car is in good shape there is some minor rust spots on the body, the frame was rusted through i had to fix it to bolt in the trans. the undercarrage will need to be undercoated as it is starting to have rust spots, it has wide tires/rims on back skinny on front all aluminum race rims it will however need new tires at some point (I was just going to roast them off) I do have the driveshaft for it but it will need to be cut down to fit the car and also have the exhaust (almost brand new) tougher springs for the rear and a b&m ratchet shift for it. also the drivers door will need a new latch. The motor is a 350 2 bolt bored to a 358 I had pakes in janesville do all of the machining and I built the motor as you can see in the pics, it has federal mogel pistons .40 over, shaved 53cc heads a lunati mild street strip cam, edlebrock intake,650cfm carb, and air cleaner, it has lots of chrome and it RUNS!!! the motor is bolted to a stock used B.O.P TH350 trans This is a good deal for someone to have most of the expensive stuff done i have about 4500 (parts/labor) into it on a project car, I wish I could finish it but my loss is your gain!!