1935 Ford

5 window Coupe

Unspecified

Unspecified

Gasoline

solid 35 5w standard coupe. you'll be hard pressed to find a more solid unrestored coupe. mustang ii front with power steering, custom low crossmember, stock spindles, all new brakes steering etc. tubular upper and lower arms. the works. 49 plymouth steering wheel on custom column. the car is pictured with stock springs and spindles. i do have a set of cut coils that will lower the front approx. 2" under floor power brake pedal assembly with dual res. disc/drum master, adj. prop valve, and residual valves rear is ranger with 373's drum brakes, ladder bar type suspension with panhard and slam re5's over rear 2 1/4" electric valves, all a/n plumbing, air zenith compr. 2 gallon tank. i have all the parts needed to finish the airride. compressor, and tank will need to be mounted wired, etc. all tubular xmembers. s brand new tanks inc. gas tank, , new battery box, new dolphin ta gauges with custom mother of pearl gauge panel. new small aluminum 3 core radiator and electric fan nice set of 35 headlights with great glass, and stainless rings. has dodge caravan front seat, and a ranger bench that can be cut down for a rear seat stainless bear claw latches, pass is tacked in, drivers is not yet, wanted to finish the floors first, hence the ratchet strap on the driver door. i have lots of parts for this project..lots.. sheetmetal is in good condition, needs patches here and there. etc...has small amount of rust at the base of each cowl corner, and at the front of each fender where it attatches to the running boards. a small section on the pass. side of quarter, just behind the door. small amounts on the rear tail pan, and the driver door could really use a lower patch. its a bit buckled. this car has a clear and open oklahoma title. with matching plate from last reg. make no mistake about it, this is a project. will need floors finish welded, and some more welding here and there..then you know the rest. interior , paint etc. i'm sure theres something i'm forgetting. if you have any questions don't hesitate to ask.. the car is being sold as a roller...NO MOTOR, OR TRANSMISSION INCLUDED. MAY CONSIDER PRE 65' 2 DR DRIVER AS A TRADE i do have a running 283 with fenton 3x2 intake with rochester 2 jets loaded on it. and a 700r4 trans that the winning bidder could purchase for an additional cost if interested