1969 Other Makes TACO T100

9H091

Clear

NICELY RESTORED ORIGINAL 1969 TACO T100 MINIBIKE. REBUILT FROM MOSTLY ORIGINAL TACO PARTS. THIS IS ONE OF THE MOST SOUGHT AFTER MINIBIKES AROUND. I PURCHASED IT A NUMBER OF YEARS AGO AS A BASIC BASKET CASE WITHOUT AN ENGINE. I ACQUIRED PARTS FOR IT TO REBUILD AS I FOUND THEM. THE BIKE WAS NICE AND STRAIGHT WITH NO CRACKS BENDS OR RE-WELDS WHEN I GOT IT. I TRIED TO USE PARTS THAT WERE PERIOD CORRECT DURING THE RESTORATION. THE ENGINE IS A 70'S VINTAGE LOW USE BRIGGS & STRATTEN 5HP THAT I REBUILT TO STOCK SPECS. IT RUNS VERY NICE. ALTHOUGH I AM NOT A PROFESSIONAL RESTORER, THE BIKE CAME OUT PRETTY SHARP! IT IS NOT MUSEUM QUALITY BUT I WOULD SAY FOR A 46 YEAR OLD BIKE PRETTY CLOSE! THE SERIAL NUMBER ON THE FRAME IS 9H091. THE 9H PART IS CERTAIN THE OTHER NUMBERS ARE SOMEWHAT HARDER TO READ THIS WOULD MAKE SOMEONE A NICE CHRISTMAS GIFT! HERE IS A LIST OF THE PARTS USED DURING ASSEMBLY.ORIGINAL TACO:FRAME, FORKS,SHOCKS SPRINGS, REAR WHEEL,BRAKE,CLUTCH COVER,REAR TIRE,THROTTLE, AND ALTHOUGH NOT ORIGINAL TO THIS BIKE, THE ENGINE TOO!AFTERMARKET REPRODUCTION:SEAT, FRONT WHEEL, FRONT TIRE (CARLISLE NON INDIAN HEAD),FOOT PEGS, CLUTCH(COMET 400 SERIES),ALL NEW BEARINGS,CHAIN,CABLES,BRACKETS, ASST. NUTS AND BOLTS(MOST ARE HIGHER GRADE STAINLESS) AND YES, IGNORE THE ZIP TIES HOLDING THE CABLES ON! NEW CABLE SPRING CLIPS WILL BE INCLUDED! WHEN I HAD THE SEAT MADE, I HAD IT MADE 1 INCH TALLER TO ACCOMMODATE OLDER RIDERS. THERE YOU HAVE IT. TAKE A LOOK AND SEE IF YOU CAN FIND ONE OF THESE ON ANY OF THE MINIBIKE SITES! THEY ARE PRETTY RARE AND ALWAYS GOING UP IN VALUE! I'VE PUT ON A GENERIC SHIPPING COST. THE ACTUAL SHIPPING COST WILL BE DETERMINED BY BUYER LOCATION. USE THE "BUY IT NOW" OPTION AND I'LL PAY THE FIRST $100.00 OF SHIPPING! I WILL CAREFULLY PACK THE BIKE INTO TWO BOXES FOR SHIPPING. I DONOT CHARGE FOR THIS SERVICE. PLEASE TAKE A LOOK AT MY FEEDBACK AND BID WITH CONFIDENCE!