1994 Ford Ranger

Extended Cab Pickup

4.0 v6

Manual

1FTCR15X7RTA31739

Clear

GAS

Due to bad bidders and people just messing around I am re listing the truck if you bid on the truck I would ask you to write me before bidding thanks...LOW RESERVE ....I have for sale a 1994 Ford ranger . I use to show this truck all over . The truck has won many awards over the years. This truck has not been shown it 5 years or so. The truck has a crazy custom paint job. The graphics flow in and out of the door jams. The frame and under side are all painted the truck was a frame off project . The tailgate handle has been shaved and relocated into the bed. The door locks and handles are also shaved and the door has a door popper installed to open it. If you want the alarm has a third channel if you wanted to use the key fob to open the door I just never used it. The hood is a Cervinis fiberglass cowl induction hood. The bed of the truck has a color matched spray in bed liner. The motor has several blue matching powder coated parts and the upper intake polished also cold air intake. The front end is a straight axle conversion it has a dana 30 front end out of a 1968 ford bronco and a ford 9 inch out back. The front axle was converted to disc brake set up. Both axles where gone through and rebuilt all new seals and bearings when built.Motor is stock 4.0 v-6 with the 4.88 gears the truck with 44 boggers would move along at 70 on expressway with no problem. The truck has much more if interested I can go over the rest. The pictures of the truck shows it with 44 inch boggers but I sold those thinking that I was going to put 49 inch Swampers on it but I never did. The only thing this truck needs is a set of rims and tires and it's good to go. Things I would do if I where to keep the truck. Picture of truck with tires just to see what a set of 44 look like on it truck will take a 49'' in tire. The other pictures are current state after removing cover. ((The 44'' boggers and rims are not included " The truck comes on the small15'' roll arounds in pictures below. Truck is ready to go no issues just needs a little clean up.The chrome on the shocks did not hold up and they are rusted and the shafts.The exhaust could be removed and just cleaned up with fresh hi temp paint. The exhaust is all one piece from the cat back so the removal is like 5 min. The headers are pacesetter headers they had the armor coat on them but it did not hold up so I would remove them and clean the surface rust off.The front drive shaft is installed but not hooked up to the transfer case. The shaft hits on the cross member I was just going to bend up a piece of 2'' DOM tube and weld two plates to it and bolt it in place of the cross member it just needs about a 2'' lower loop to be able to hook up. Local pick up only.Cash upon pick up and $500.00 deposit through paypal within 24 hours of close of auction. Must pick up within 5 days.The truck is for sale locally so I reserve the right to remove this add at any time .