1929 Ford Model A

2 door sedan Sedan

4 - Cyl.

Manual

A2040597

Gasoline

The gentleman who owned this model A had collected parts for about 30 years, but unfortunately did not have theopportunity to complete the project. There are lots of new and used pieces and parts. This 2 dr sedan could be restored, ratrodded, or put together as a great old style hotrod. I will start out by listing the NEW parts which go with this critter: Frame covers (directly beneath the hood)...Stock steering wheel...Hood latch and hardware kit...Headlight socket and wiring kit...Headlight and tailight flex tubes...Firewall forward wiring harness...Sill plates...Metal footwell cover...Completely restored and rechromed headlights with perfect glass lenses ($500)...Clutch plate...Spark plugs ($100)...Gas level siteglass(2)...Restored dashplate, rechromed...Ampmeter (2)...Rebuilt Zenith carb ($250)...Distributor ($150)...Coil...Solenoid (2)...Radiator cap/motometer temp indicator ($250)...Gas tank cap...Bevelled rear view mirror...Webbing rolls (4)...Shackle kit...Taillights (2)...Oogah horn...Crank pulley...Water pump...Running board cover material...Piston set with pins...Piston rings...Radiator hoses...External oil filter kit...Intake/exhaust manifold with cast in heater...Body to running board aprons...gasket set...Bumper hardware kit...Shock rebuild kit...Ignition shutoff cable and key switch...Crank bolts (2)...Lots of nut/bolt/spring/bracket/etc kits, still packaged. Look closely at the pictures. Parts with previous experience: Frame complete with springs, front axle (bent a little), rear end, drive shaft, transmission, steering column, and some bumper brackets. Body No 1...2 door sedan with surface rust, doors, window mechanisms, cowl, tank, and visor installed. Has slight rust through at lower cowl, and a hole in the rear fender recess. Body No 2...2 door sedan with surface rust. Has rust through at lower quarter panel. Body No 3...Ditto number 2, but not as nice. Gas tanks...2 nice usable, 1 rusty. Cowl units...2 usable with minimal rust Seat frame...2 front jump seat frames with some springs Front fenders...1 set which are near perfect, 1 set which are repairable, 1 set wich is pretty rough Rear fenders...1 set which is near perfect, 1 set which is repairable, 1 set which is pretty rough Hood...1 complete hood set which is near perfect, 1 which is useable. Doors...2 sets ofusable doors in addition to those on Body No 1. Miscellaneous parts which include an engine block, 2 transmissions, bellhousing, wheels, 2 Tillotson carbs, lots of stuff. Engine...Model A, but I do not know the condition. It looks to have been rebuilt, then left sitting for many years, some outside. There is more that I have not listed, and I will do so as I identify. Please call if you have questions......Bruce (208) 453-8606 Please leave a message if I do not answer, and I will call back ASAP!!!!!! NOW........LET YOUR IMAGINE RUN A LITTLE WILD....THINK WHAT ALL THE POSIBILITIES ARE FOR THIS MODEL A... RESTORED WITH PARTS LEFT OVER EARLY HOT ROD, FULL FENDERED OR HIGHBOY WITH A Y-BLOCK (TALK TO ME) RAT ROD, YOU COULD BUILD THREE