1972 Ford F-250

Cab & Chassis

428

Manual

F26YRP80157

Clear

Gas

Title is clear but not currently registered. Truck has a 428 long block form Ford that replaced the original 360 . I have that paperwork. The top end is all Edelbrock products. The heads have maybe 80 miles on them. Last year while in the driveway it dropped the number 2 piston skirt. As far as I could tell no other damage way done. Truck runs and drives but rough. the engine needs to be pulled and gone thru. Block has been bored .40 over, has Isky solid lifter cam, Edelbrock heads, Performer manifold, 750 Edelbrock carb, Headman headers. Fairly new exhaust system. Its a thumper! I have the original spring set along with a two barrel manifold and air cleaner. New floor pans are in but not welded. Needs cab mounts, both sides and passenger side cab to radiator support rail. Bed is weak but not terminal.I have 2 spare doors , passenger side front fender, new black door panels, chrome scuff plates, new black dash has been installed all from Dennis Carpenter. Also 2 spare sets of 390 heads, (need work) 2 holly 750 carbs, a 650 Edelbrock carb jetted for 6000 ft. Spare transmission good condition. Assorted body badges and original radio. This truck is one of the few with factory air and I have the all the parts to reconnect it. The heater core needs to be replaced.The drive train is in good working order, rear differential rebuilt 4k ago, new clutch 500 miles ago brakes are good and tires have little wear. 37.5 Swamper radials. If your are an engine and body man this truck has "HUGE" potential. Thanks for looking