1967 Chevrolet Chevelle

2 door

427 big block

Manual

67-13617

Clear

Gasoline

This chevelle is well on its way to a first class restoration. It has a rebuilt 427 with forged pistons and a forged crank. It has not been started yet. The trans is a borg warner 5 speed. The body was put on a rotisserie then sand blasted as was the frame and suspension parts then they were epoxy primed then the frame and parts were painted as were the under side of the body and firewall. The body was placed back on the frame and the body work done and the body primed. Here is a list of new parts that are included, some installed and some still in the package: complete front power disc brakes, brake lines, front and rear shocks, control arm bushings, front sway bar bushings, rear wheel cylinders, brake shoes, water pump, fuel pump, clutch pedal and linkage, scatter shield , fan shroud, front bumper, rear deck lid molding, rear body panel molding upper, rear body panel lower, wheel opening moldings, glass run channel, body bushing kit with hardware, door hinge repair kit, ss dash emblem, outer grill extensions, ss hood, front bumper, ss grill, headlamp bezels, hood edge molding, battery tray, tail light bezels, wiring harness, The interior had been replaced a few years back and some of it may be usable and some may not. The rear drums have been turned and the heater control panel has been completely rebuilt, and the flywheel has been turned, it also comes with a used flowmaster exhaust that is for a small block and needs modified to work .I just saw my pictures on the computer and obviously the under side is very dusty, I cant get down on the floor and clean it or take a decent picture (health reasons are why im not able to complete the car) but its just dust and will wipe right off, the under side of the car is immaculate and the interior is much better than it looks in the pics. I listed most of the things needed for the car above but I just remembered it needs a front bumper filler. I have most all the rest of the parts needed as this was a complete running car before I started the restoration. some of the things that I can think of that I have are the rear bumper, inner fenders, drive line, petronix distributer, side and back glass dash components, window regulators door handles, vent windows nuts bolts all the old trim, basically. I saved everything I pulled off of the car The car is for sale locally so I may. may end the auction early if reserve has not been met.