1957 Chevrolet Other Pickups

Pickup truck

8 - Cyl.

Manual

3A57W109199

Gasoline

Lots of fun 1957 Chevrolet 4x4 napco stepside pickup truck with factory napco frame that has been updated with a Dana 44 with front disk brakes and new warren hubs in the front ( 8 lugs) and a Dana 60 (8 lugs) in the rear both with chrome covers. This 283 ci v8 runs good with a 4 speed manual transmission, manual steering a new radiator, headers and new exhaust mufflers. New chrome bumpers front and rear. Notice it has a 1956 front grill but the truck is a 57. Body is very straight and has very little rust. I have a box of new weather striping and window latches that go with truck. The bad is the heater needs to be hooked up, the truck bed floor is plywood so you could use as is , some of the wiring could use up dating its old school so very simple to do. The front drive shaft needs u joints, no radio, but the radio hole is stock not chopped up. needs chrome body side trim, speedo and some gauges are not working that's why some wiring needs updating might just be the ground? The truck is two tone primer grey/brown so you can paint any color you like. Clean california title in my name in hand any questions please ask before bidding. $1000.00 deposit due at the close of auction with bal due within 7 days. If you need help with transport I will do what I can within reason on this end and can deliver within 200 maybe more miles for a small fee if needed?  Good luck and enjoy ! Chevy gmc 55 56 57 four wheel drive 1955 1956 1957 tri five 5 step side pickup truckOn Jan-28-12 at 14:29:25 PST, seller added the following information: I thought I should post some of the questions and answers I've got  Yes it starts and runs strong Yes it drives fine, well like a 1956. Yes has granny Yes stock napco trans and trans case.  Frame is stock and good Send me email address and I'll send pictures under drive area. All elect light etc. work , I ll have to check the wipers have not used wipers in awhile but the wiring is old and could use update as noted in ad some gauges and speedo don't always work.  Don't have axles  Call if you have more questions just not late please Regards ken Does the truck run and drive in its current state? Is this the 3-speed with granny low transmission? Is the transfer case original NAPCO? Do you have the original axles? Do you have any pictures of the frame? What kind of condition is the frame in? Do the headlights, signal lights, wipers work? I am interested in the truck Hello I don't know the number of the transfer case it the stock napco transfer case works and sounds fine, it has the napco emblem on the dash I'll look in my box of stuff but I don't think any other emblems are there but I'll check. This is a link to a picture of the transfer casehttp://i1103.photobucket.com/albums/g470/apps4now/955363c8.jpg  Not sure what ratio it is but it will drive 65 mph just fine Hope this helps Thx ken What transfer case does it have (picture would help)? What condition is it in? What is the gear ratio of the differentials? Do you have the 3100 side badges? Do you have the NAPCO emblems? The floors are good other than it needs carpet or floor mats, transmission works just fine it is stock so it still has granny first gear, front and rear in good shape out of a 3/4 ton Chevy I think, the prior owner had done all that work. Both are 8 lug. this truck have solid floors hows the transmission and rears ,what are the rears out of