1966 Ford Mustang

Coupe

6 - Cyl.

Automatic

6t07t169403

Clear

Gasoline

Car was a daily driver and had transmission replaced last summer mand the carb was rebuilt. Some areas of rust and paint is poor. I tried to get close up photos of the areas. When transmission was replaced they did some additional work. I'll list everything from their invoice below so you can see what was done There is a new gas tank that goes with the car, we have not installed it yet so it will go with the sale. Also included are a new Gas tank - not installed New glove box - not installed New arm rests. - not installed Rebulit carb 2010 64-1/2-66 EARLY NEUTRAL SAFETY HARNESS 65-69 6 CYL FRNT U-JNT 65-66 FRONT U-JOINT FLEX PLATE BOLT 64-1/2 - 68 A/T SHIFT LEVER A/T SHIFTER BUSHING 65-67 A/T 65-66 A/T SHIFT COVER C-4 TRANSMISSION REBUILD STRTR 65-200, 390/428 66 6 CYL TRANS LINES Glassbeaded housing,arm, and plate. Painted parts with cast iron gray paint. Supplied and installed new shifterbushings and lubed with grease. Supplied and installed new shifter lever, handle, and bezel Lubed and adjusted as necessary. Removed driveshaft, starter, linkage, wiring, and crossmember from parts car. Removed trans, flex plate, and engine plate. Removed driveshaft, starter, shifter, z-bar, linkage, wiring, crossmember, transmission, bellhousing,clutch, pressure plate, flywheel, engine plate, and pilot bearing from customer's car. Removed and reinstalled alignment dowels for small auto bellhousing on rear of block. Cleaned and reinstalled engine plate flex plate and flex plate retainer. Cleaned crankshaft bolt holes and installed new flex plate bolts with Teflon thread sealer. Torqued to specifications. Temporarily removed gauge cluster. Drilled 3/4" hole through firewall forneutral safety harness. Supplied and installed neutral safety / backup light harness. Reinstalled gauge cluster. Trimmed carpet as necessary for shifter. Tapped mounting holes. Installed shifter and bezel. Disassembled and cleaned driveshaft. Supplied and installed new U-joints.Cleaned linkage, cover plates, vacuum line, etc. Installed torque converter into trans. Installed trans onto engine. Reinstalled crossmember. Cleaned and adjusted neutral safety switch. Supplied and installed used kickdown lever. Adjusted kickdown cable. Supplied and installed new starter. Supplied and installed used ground wire. Supplied and installed new cooler lines Paint is poor. Clear coat is peeling. Pictures do not do it justice. Rust spots on door and rear quarter wheel well. See photos. Any additional questions, please email me. Low reserve of only $3500.00. $500.00 non refundable deposit due within 12 hours of auction close. Payment in full within 3 days. You must arrange your own pickup. Serious bidders only. No refunds. I have included as much information as possible to the listing. Please ask all questions before bidding. On Oct-03-11 at 16:27:14 PDT, seller added the following information: I have been asked if the car runs or not. I took 2 videos for you all to see that it does indeed run. If there is anything else I can answer, please just ask. $3500.00 takes it away. http://www.youtube.com/watch?v=RCCNtCPqjLQ