1988 Chevrolet C/K Pickup 1500

cheyenne Pickup truck

8 - Cyl.

Automatic

1gcdc14z7jz206050

Gasoline

No Rust, No Dents... solid as a rock.. great launching pad for a simple street rod project or just thrown on some new $150 headers and a couple hours & she's a clean, solid daily driver... Revised: oops sorry... its a 1988 not an 1989 :: 160,000 On the clock :: Current Driveline has less than 60,000 miles :: Has Rochester Carb 4 barrel on it now. Originally the fuel delivery setup was off a Camaro with TPI. The old ECM's, harness &fuel lines were left in tact and could be easily converted back to TPI, TBI or any other fuel injected setup . I did not take off original injection setup off this was done by the previous owner :: 305 Vortec with TH700r Trans Motor was changed at 102,000 or so and this motor has 60,000 +/- miles, It runs as well as drives excellent! :: Runs, Drives excellent & FUN TO RIDE! :: Dual exhaust :: Truck originally from California and has ZERO ROT or RUST! Give her a good buff and she'll shine up very nice! Entire cab, all corners, rockers, bed etc are all squeaky clean, solid and absolutely straight & with no dents either :: Slightly Lowered & sits very nice! :: Good Brakes, Good rubber with nice & simple aluminum alloy rims. (a good polish will make them shine again) :: New GM scrapers Installed to both doors inside & out :: Very clean and simple interior. Has A/C but needs recharge original radio is there but is not connected. :: I also have available a brand new, in the box, never installed CRL dark tinted power-slider vent rear window. Original cost was $580 if you want it with it I will let it go along with the truck for an extra $200 and you can have it installed at your local auto glass shop. :: Needs new headers Behind the headers all the pipes are all sold & right where the the current headers (hooker) drop down pipe underside simply rusted through .. A new set of headers run about $150 from hooker or heddmen. And probably an hour or three to install if you are mechanically inclined. all the piping after the headers are fine & clean. :: The gauges on the dash, while the speedometer & fuel gauges work. The voltage, temperature & oil pressure are not hooked up. There is a small under dash cluster I just threw on so I could see oil pressure but the voltage & temp are not connected on that either . :: Needs either a couple bulbs for the rear running lights or there is a simple loose wire maybe. LOCAL PICKUP ONLY If you insist on shipping my truck then I leave it completely up to you to do the ALL the logistics and it must be picked up from my driveway within 5 days as well as I will add a 3% buyers premium for the hassle I will not drive it anywhere for any reason to be dropped off somewhere and personally I don't need a vehicle shipping headache. THIS IS A USED VEHICLE IT IS SOLD AS IS & WITHOUT WARRANTY Any questions? Just ask... (This isn't Wal-Mart, get it?)