1969 Chevrolet Chevelle

Sedan

350

Automatic

134279K339604

Clear

Gasoline

1969 Chevelle project car. I've had this car in my garage for 4 years, and have replaced most of the sheet metal. Unfortunately, I just lost interest in it. The engine is a 350 out of a late 80's or early 90's truck. I drove it ten miles home four years ago and it's only been in and out of the garage since then. The oil pressure is good and the engine has headers, aluminum intake, MSD HEI distributor (new) and an Edelbrock 1406 650 CFM carb (new). The transmission is a TH400 with a new stock stall converter. I rebuilt the transmission a couple of years ago, but it doesn't have any miles on it. The radiator and battery are new also. Body mounts were replaced with Energy Suspension polyurethane mounts. Motor mounts and transmission mounts are new stock replacements. Driveshaft is a custom 4" Aluminum shaft. The factory brakes were upgraded to four-wheel power disc brakes with a complete kit from Right-Stuff Detailing. While upgrading the brakes, ball joints and wheel bearings were replaced. New AMD brand sheet metal includes:Full length DS & PS floor pansDS & PS Rocker panelsDS & PS Front FendersDS & PS Inner FendersRadiator Core Support (Original Parts Group)Full Trunk PanTail PanelRear Speaker ShelfDS & PS Inner Wheel HouseDS & PS Outer Wheel HouseDS & PS Full Quarter PanelsFull Roof PanelDS & PS Drip RailsThe roof panel has not been welded in place and is just sitting on car. The original hood, trunk lid and doors are in good usable condition. I have an American Autowire complete wiring harness that has not been installed and four new door hinges that haven't been installed. All of the glass is decent other than the windshield which was cracked. The car had no interior when I bought it and still doesn't. My reserve is less than the cost of the parts I have on the car, I'm just ready to move on. Car will have to be transported in an enclosed trailer since the roof isn't attached. Local Pick-up Only!