Detail Info for: 1947 Willys CJ 1947 Willys CJ2A

Transaction Info
Sold On:
04/16/2017
Price:
$ 2500.00
Condition:
Mileage:
52177
Location:
North Manchester, Indiana, 46962
Seller Type:
Private Seller
Vehicle Specification
Year Make Model:
1947 Willys CJ
Submodel Body Type:
SUV
Engine:
Transmission:
Manual
VIN:
4LR106514A
Vehicle Title:
Clear
Drive Train:
Fuel Type:
Gasoline
Standard Equipment:
Optional Equipment:
Vehicle Detail
Up for auction is my 1947 Willys. Wife says she wants her garage back. Bought this in 2009 but lost my job and new one didn't allow me the time to continue work. Last 6 years it's been on jackstands in my garage collecting dust. Stripped it down to the frame sent body to be sandblasted. Cleaned up frame than Coated frame and underside of body and interior with Herculiner. Car was originally from Southern California so had very little rust. All sheetmetal was in good shape except under the left tail light where it was rusted out and the right fender support needed to be replaced. Also had a rusted out place on the floor brace on the drivers side I had to patch. New Parts All new gauges except speedo and tach. All new brakelines, wheel cylinders and master cylinder. Steering column Jensen Marine am/fm disc player w/remote Shocks LED tail lights Speakers (2) Others that I can not remember right now but will include later. Previous owner had upgraded to Saginaw steering gear and drum brakes. I used all stainless steel nuts and bolts on outside and most everywhere else. Drivetrain is all original with Overdrive except the engine which I was told when I bought it was a recently installed small block Chevy crate engine. The Title is clear not salvage my guess is the VIN was issued by California on a build. Mileage is unknown, I just entered what shows on the speedometer that comes with it. Have most of the parts needed to complete including windshield and new seals. Now for the bad. The engine has not been started since I drove it into the garage. The auto choke on the carb has been gutted. The wiring needs to be completed. Brakes have not had any brake fluid in the lines yet and I believe I have connected an auxiliary hydraulic brake backwards. Steering column and shaft need to be finished. Either replace the joint or install a bearing on the shaft. I have a new knuckle but right now I've got a double knuckle so I couls steer it out of the garage.All the lug nuts are left hand. PLEASE ask if you have any questions or concerns. Will post more pictures of the work when I can find them. On Apr-11-17 at 05:40:14 PDT, seller added the following information: Has a suspension lift of 4 inches or more. 2 Pyle Marine speakers. There was a rear gas tank when I purchased it but was going to replace it with a new one for a CJ 5, still has the original under the seat. Still needs fuel lines run. The seats are just some I had laying around the garage and the passenger seat is not bolted to floor. I have a good hood that goes with it. As can be seen in pictures the cowl has been cut to allow access to the Chevy distributor.On Apr-12-17 at 10:18:48 PDT, seller added the following information: Have a good hood that goes with it I found in shed this morning.