1985 Porsche 911

Coupe

3.2

Manual

WP0AB0910FS121389

Clear

This 1985 Carrera 3.2 is a driver, not a garage queenThe reason you should want this 911 is for its engine with 21000 miles on rebuild.Supertec performance head studs, stronger than arpHigh flow oil pumpHigh performance camsracing timing chainsbalanced connecting rodscross drilled and polished crankReceipts for all work completed by Supertec Performance This is my perfect 911 that I designed to be everything I ever wanted in a Porsche. I have put a ton of work getting it to this point. Everywhere I go people always compliment the car and I frequently get asked if it's for sale. Well now it is. Here is a list of everything I have done. Starting with the rebuilt better than new engine by supertec performance. Complete suspension and brake overhaul - Bilstein sports inserts-Boxster brakes-stainless lines-rebuild racing adapters-slotted rotors-Porterfield Pads-Turbo tie rods-Spherical front bushings by rebel racing -rebel racing motor, trans mounts2/28 torsion bars -Corner balanced-aligned at West end alignmen-triangulated strut brace The only part I haven't touched is the transmission which the previous owner had rebuilt. The inside has been stripped of weight, weighs about 2400 lbs-recaro spg seats -wevo shifter, new tires -classic retrofit modern fuse panel-Steve Wong chip and rebuilt dme by Steve Wong There is also the orignal dme and chip which i keep for smog checks and a near new cat -solid state dme relay that will last forever as well as two spares-Das Sport Roll bar that is bolt in -schroth harnesses amp under seat-Boston acoustic speakers-aftermarket digital gauges, speedometer gps-Bosch h4 headlights with 100 watt bulbs-ceramic wire harness-Rsr light weight door panels-Custom made spoiler utilizing 996 turbo wing.-Rear wheels weltmeister 16x8 with 15 mm spacers and longer studs-Front wheels are Fuchs 16x7 rolled fenders-Momo steering with spacer-Seats are bolted to the rails for lowest cog-New front and rear lenses-hood seal-windshield wipers -ignition switch-quarter window 993 seals-windshield seal, turn signal stalk Many items were removed to add lightness starting with the interior sound deadening, center console, sun visors, rear seats, and was replaced by lightweight carpeting. In the engine, the ac was all removed leaving lots of room for engine bay. The frunk the fresh air system is gone. However the heat works very well without the blowers. The only problem is a vibration sound that comes from a frame in the sunroof and it needs the horn to be rewired.