1950 Ford Other Pickups

F-1 Pickup Truck

Chevrolet Small Block V-8 283

Manual

Clear

Gasoline

1950 Ford F-1 Pickup with Clear Title. This Truck was customized some years ago. The restoration or resto-modification was started and about half way complete, when the owner passed away. The truck sat is storage for years and was recently completed. The Modifications consist of a modern V-8 Chevrolet Engine. The Engine is a 1960's model Chevrolet 283. It was refreshed with new internals, including Oil Pump and Timing Set and Seals and Gaskets. This is a low mileage engine and the Bore and Bearings were good, so it was not Bored or Turned. Everything inside is standard. The 283 has a Holley Manifold, Holley Valve Covers and Holley 4 Barrel Carburetor. The Engine also got an Accel Electronic Distributor and new Wires. The truck got a 5 Speed Manual Transmission from a 1990 Chevrolet Pickup. I believe this transmission is called an NV-3500. This gives the truck 5 gears and a Hydraulic Clutch. Along with the Transmission, the truck got a new Flywheel, Clutch and Throwout Bearing. A new Driveshaft was fabricated by a local Driveshaft and clutch shop. This was a little expensive, but so much better than hacking a couple of old driveshafts together. The Truck already had a later model Ford Differential, giving it a more street friendly set of gears. The Truck was changed over to 12 Volts and got a GM 1 Wire 90 Amp Alternator. There are also lots of other new parts including Starter and Fuel Pump. There is much more. The Truck now has Power Brakes with Discs in the front. Everything in the brake System was replaced, including Master Cylinder, Rear Wheel Cylinders, Shoes, Lines, Hoses and more. The Truck has Headers and Dual Exhaust that turns down near the center of the Bed. The Frame is very solid and is painted Black. The Body is solid with a little rust, here and there. The Cab has all new Glass and Window Seals. All of the Door Windows open and close properly. The Seat is a Vintage Ford Truck Seat that looks good with the Truck color. It was recovered some time in the 1960s or 1970s, but still looks good. The Seat is not perfect. It has some wear and tear from the years, but is just too cool to recover. The Truck has an Oldsmobile Tilt Steering Column and the High, Low Beam Lights, Turn Signals and Emergency Flashers all work through the Stock Column controls. The Gauges all work. The Fuel Gauge works properly. The Oil Pressure and Temperature Gauges seem to work backwards. I believe this to be because the truck was originally positive ground, but that is just a guess! The Speedometer was replaced with a tach. There is a power port installed on the dash. This is a good place to insert a power cord for your GPS. The GPS will give you an accurate speed reading. The truck also got a new Headliner and various other new parts from Dennis Carpenter. The Doors open and close well. I am posting pictures of the Cab Corners and Door Bottoms to show their condition. The Front Fenders are Fiberglass. The Hood, Grill and Center Section are Steel. There is a sheet of Steel, welded in the Bed. The Tail Gate is original and in good condition. The Tail Gate does need one Hinge to work properly. There is no Rear Bumper. The Wheels and Tires have only a few hundred miles on them. The Wheels are Chrome Reverse with Baby Moon Hub Caps and in good condition, not mint condition. They are all 15s, but the front Wheels and Tires are smaller than the backs. This gives the truck a lower look, in the front. The Truck has an attractive look with nice artwork on the door and a nice Patina effect. It is not a show truck, but a fun cruiser that gets plenty of attention. I tried to describe the truck well. I am sure I left out some things. I will try to answer any questions through email. I may be able to assist with delivery within a few hundred miles of Canton, Ohio. This Truck is being listed with a low start price and no reserve. It will sell to the highest bidder. Please look closely at the pictures. They are part of the listing.