1967 Chevrolet C-10

C10 Pickup Truck

292 Straight Six

Automatic

CS147B142411

Clear

Gasoline

1967 Chevy Stepside truck. Recently rebuilt 292 engine; Automatic. Very usable truck. Rough / old paint job. Could use additional interior and exterior work, unless you just want a functional truck and you can drive and use as is as we have for 4-5 years. Good for a restoration project. GM 292 straight six rebuilt and bored .030 over. Rebuild has less than 500 miles on it. Holley 4 barrel carb with an offenhauser 4 barrel intake. Clifford long tube headers that have been repaired at the flanges, dual exhaust all the way back. HEI ignition from a late 70s truck has been installed as well with new plugs, wires, caps, rotor, coil. Turbo 350 automatic with a minor shift kit of some sort has been installed. Truck originally came with a 250 straight six and a 3 speed on the tree. Conversion was done to an automatic prior to my ownership. The 250 in the truck originally blew a head gasket and the 292 was sourced then rebuilt as described above. Power steering is currently in the truck but not hooked up, proper bracket for a 292 is needed. The bed bottom was replaced with a sheet of steel prior to our ownership with the installation of fiberglass repro rear fenders that are in excellent shape; these could be used on a short bed or a long bed from my understanding. Rust is located in the bed sides, rear tailgate, rockers(new included), top of cab along the windshield but the cab corners are fine. Windshield is currently cracked with a newish Pilkington windshield being included in the sale, we had planned on fixing the top of the cab prior to replacing the windshield. Blower motor currently works but the heater core needs minor repair and has been bypassed at this time. Simple solder joint need to be done to repair the heater core and can be done prior to the sale. Buyer is responsible for shipping. If you have any other questions please do not hesitate to ask.