1947 Ford F-100

8ba v8

Clear

I hate to see this project go but I don't have the time to continue it. I have the title and DMV fees are paid for in CA. I was just awaiting to get it running to take it in and register.  A lot of work went into this truck and I have compiled just about everything needed to get her back on the road. All the new and NOS parts cost me a small fortune not to mention the engine and transmission.  Cab info: Rust repaired on door bottoms and cab corners. (I would replace passenger floor board\s) -8ba Flathead Motor\Transmission (COMPLETE) Pulled from running truck -12v alt installed on the flatty (kit from Mac Auto) -New Auto lock door popper kit with 35lbs solenoids + door poppers -New mustang gas tank with fuel sender -New COMPLETE Wiring Harness (front to back) brand new -Altman easy latch kit NEW -new headlights + new chrome rings -new tail lights + Chrome Brackets -wire looms for tail lights -New horn relay -New 12v relay -New ignition column with key and switch (rebuild BRAND NEW NOS) -2 original heaters -heater controls -NOS heater switch (NEW) -orig front bumper -running boards -New window felt trim set (for glass) -New door handles -rear drive shaft gasket installed -New rear drum brakes and master cylinders installed -front and rear fenders -new u joints Lots of stuff Im missing but anything I have for the truck is included in this sale. Everything is here to make her run just don't have the time to finish it.  ***Truck bed was rusted out no longer have it...was going to replace it with after market bed kit**** 760-477-3534 Adam On Nov-08-12 at 07:48:53 PST, seller added the following information: I forgot to mention Gas tank is already installed...and the pop locks and new lock regulators. Doors open and close like new. The door handles are shaved and locks work perfect!  Head Light Connectors (already wired and hanging. Pop locks installed and solenoid is on the firewall along with wiring and grommet.  Wiring for the engine bay is already ran and ready for hookup. Fire wall  New radiator hoses already installed along with Alternator kit for the flat head. On Nov-08-12 at 08:09:27 PST, seller added the following information: Here are a more pictures I have of the project NOS heater switch (VERY HARD TO FIND) Installing the new cylinders So many new parts for this truck. This is the old rear end that was no good..I picked up a nice working one in LA for $1,000.00 and put her in. I also installed a new rear drive shaft gasket. (NO LEAKS) Here is a new REBUILD NOS key\column (Look them up if you can find them $500.00+) New ujoints and gasket.  New gear oil and picture of the Alternator kit Doors were taken down to metal and hit with primer. (NO RUST) Roof was taken down to metal and hit with primer (before shot) After shot Early picture of dropping in the new engine. These seats come with the truck. They are out of a Silverado and have built in seat belts.