1986 Jeep Cherokee

SUV

3.4

Manual

1jcwl7833gt215386

Clear

Gasoline

OME 934's and JC1A's w/RE shackles and OME long travel shocks (3" lift) Adj lower control arms and JKS sway bar disconnects, 31x9.50 TSL radials on Canyon Rims. BPI rear bumper, KargoMaster rack, AJ's front bumper w/ push bar, Reflexxion Cowl hood, XJ Nation skids. 4:10 gearing, Posi-lock, Great running 3.4 w/weber. Engine has approx. 90,000 miles on it. After 9 years it's time to move on, When I got it everything was put in tip top Mechanical shape, new unit bearings, new cross drilled rotors, brakes, cat converter, went through and freshened up the t-case, New water pump and radiator, ect... Here's the bad 1st - tranny is shot, comes out of gear when no load is against it, floor boards are getting soft, the repair job done when I got it needs redone I guess. Rust is starting to get worse behind rear wheels. most likely needs rear brakes. There's a few things electrical that I can think of - Fan switch quit working so I wired it to run on high, I had an issue with the headlight switch this past winter and cracked the plastic pulling it out to fix it so the switch is hanging under the dash ( if I can find the piece which I saved it'll take 10 sec to fix with some super glue) and the fuse for the turn signals likes to come loose occasionally apparently the contacts in the fuse block for it aren't springy anymore. And the tach operates sporadically. I was daily driving it on and off up until this past Feb when the tranny started acting up, the engine is strong and the rest of the drive train is very solid other than the transmission, the interior is in very good condition other than the saggy headliner and the shifter boot won't stay where it belongs because of a crack in the console where it clicks in. Swap another tranny in it and drive it while ya fix the other things...... I know it's worth a whole bunch more as parts, if I had the time and place to take it all apart now, but I don't.