1990 Honda Civic

dx Hatchback

4 - Cyl.

Manual

2HGED6343LH519122

Gasoline

1990 Civic dx hatch b18a1 swap Block: Arias 11:1 CR Pistons Eagle Rods Honda/Acura OEM Bearings Head: Crower Valves Crower Valve Dual Springs Crower Titanium Retainers Crower Stage 1 Cams Moroso Spark Plug Wires NGK Iridium Spark Plugs Tranny: S1 ACT Streetlite Flywheel OEM Clutch (lots of meat left) Avid Racing Shift Linkage/Short Shifter Suspension: Ground Control Coilovers with Autozone Shocks BLOX Rear Control Arms Exhaust: Heat Wrap(ed) DC Header KTeller 2.5" Straight Catless/Resinatorless Piping with Magnaflow Muffler Extra:Avid Mounts Unorthodox Racing Crank Pulley Unorthodox Racing Alternator Pulley Skunk2 Cam GearsSkunk2 Radiator/Valve Cover Caps b18b1 valve cover Custom Wrinkle Finish done at 400degrees Brand New Front Windshield with Molding Brand New Interior Seat Covers Custom Work (Front/Rear) -Hot Tanked Block/Head, Ported Intake Manifold Runners/Throttle Body and Intake/Exhaust side ports -Leakdown Compression Test 200psi throughout the cylinders -p28 ECU with MONOTECH made engine harness DPFI to MPFI and Obd0 to Obd1 A descent wiretuck is done like shown in the pictures, everything soldered -Rear disk conversion -Alignment Done at Firestone To start of, this has been my piece by piece project for over 2 years. I always wanted to have a jdm old school sleeper and a 300 shot of spray in the trunk, but the dreams of me finishing her up came and gone due to a financial situation. It has come to hand it down to someone who has time. Being in work/school doesn't give me time to do anything on the car, but I do try to keep it clean and stop rust from eating her. Motor was put together at JL Engines in Alison, Iowa in late '08, beginning '09. Engine has about 1 mile since the startup, it was taken around the block 4 times to insure the motor runs flawlessly, this was done about 6 months ago, since than I have started it up and let it run every once in awhile. Head was retorqued after the startup, 5 ft/lbs over spec. I want the buyer to tune this motor at a local tuning shop, other than that I cannot guarantee that it will be a road/race ready car. All the work was done by me and my neighbor who is a CNC machinist and a very good backyard mechanic. I will include interior honda oem seat covers that need to be sowed to the seats. Alot of the exterior/interior parts are in the trunk, rear seat area. Only piece in the exterior that is missing is the bumper PROJECT THAT NEEDS TO BE FINISHED! Will deliver for free if buyer lives 150 miles (or less) from Waterloo, Iowa Any questions, more pix, information on motor, etc. Please feel free to PM me. IM IN NO RUSH OF SELLING THIS PROJECT.