1973 Triumph TR-6

1973 Triumph TR6 Phoenix NO RUST Always Garaged Convertible

2.5 liter 6 cyl

Manual 4 speed

CF1603U

Clear

Gasoline

Picture DropBox link ---> https://db.tt/ZKArkBSU 1973 TR6 111K miles First owner in N.J. area, Second owner brought to Washington, DC in 1974 Then to Arizona 1978, when I acquired car in 1985. Always garaged. Runs well starts easily. 5 very good redlines, Spare w/o wheel, good TR4 spare in trunk. Partial Restoration 1995, Garaged Since. Started body off With full Suspension Running Gear restore. Unable to complete due to health issues. Have new complete Body seal and body mounting Kits. Have garage full of parts... Rebuildable spare J-type overdrive trans, Questionable A-type Overdrive, Spare short block Manifold, carbs etc. Tons of extra parts go with the sale Slideshow linky ---> http://s111.photobucket.com/user/japcarrealgood/library/1973%20Triumph%20TR6%20Phoenix%20NO%20RUST%20Always%20Garaged Sold as-is with no written warranty or implied.On Jan-19-15 at 20:15:21 PST, seller added the following information: Videos: https://www.dropbox.com/s/1wgdpe9j93cx2j8/TR6%20starting.movStarting ^ https://www.dropbox.com/s/1wgdpe9j93cx2j8/TR6%20starting.movRunning with choke ^ https://www.dropbox.com/s/mt1ymy6ek0t96nj/Tr6%20running.movRunning ^ https://www.dropbox.com/s/mt1ymy6ek0t96nj/Tr6%20running.movDriving 1 ^ https://www.dropbox.com/s/urjo9a8nvo2bzlp/TR6%20driving%202.movDriving 2 ^ On Jan-24-15 at 14:30:05 PST, seller added the following information: At Coventry motors $12,000 was spent on a partial restore around 95k milesThe ARA (Texas) AC system is from a dealer installed set up, front pulley fan piece, has secondary pulley to run the AC. The original compressor was York, I replaced it with a Sanyo rotary. I originally had a 6x12 condenser with 4 blade 6" fan, now it has 12x14 condenser with a 12" fan. It gets 40 degree air in the summertime when it's 110 degrees outside in Phx. All aftermarket parts are from roadster factory. Fiber board radiator shroud replaced with custom made aluminum alloy pieces. I have a new rear sway bar, bushing, and hardware to replace the missing one.