1964 Toyota Land Cruiser

Wagon

Inline 6

4FJ4515102

Clear

Gasoline

This is a 1964 Toyota Landcruiser FJ45 LV wagon. This is an unrestored original that is very complete. It has the original inline 6 cylinder motor with the 3 speed column shift transmission. Axles are original with 4:11 gear ratio. The interior is also original. This vehicle was a daily driver until 2007 when the clutch failed. It has been parked since that time. The clutch master and brake master were recently cleaned out and filled with fresh fluid. The brakes and clutch functioned but the fluid leaked out by the next day. The master cylinders did not have any significant pitting and would likely function with a rebuild kit. (The clutch master and slave operated but it still needs a new clutch and pressure plate.) The carburetor was also cleaned out and filled with fresh gas. The fuel line from the tank was disconnected as the gas has fouled. The engine fired right up and idled smoothe. There was minimal rocker noise and no other unusual sounds. This was a good daily driven motor before it was parked and should continue to run fine with fresh fuel and a minor tune up. The carburetor is a Rochester single barrel unit from a 50s or 60s GM car. This was a popular conversion back in the day and the stock oil bath air cleaner fits right on it. This rig also has a GM alternator conversion and a remote oil filter set-up that uses the standard PH8A filter that newer Cruisers used. This Cruiser has the typical rust for this year. The worst is in the rear quarters and the front of the rear wheel wells as shown in the pics. The drivers side front floor board also has rust. The frame is solid and still has original paint in some areas. The axles are solid as well. There is no significant pitting in the metal like you see on cars from the eastern US or coastal areas. Shock mounts, gas tanks skid plate, drivelines, rear sway bar, and other pieces are present and in restorable condition. Tires are new 31x10.50R15s and are mounted on 1976 FJ40 wheels. These wheels can be used when doing a disc brake conversion. Besides the rust, this Cruiser also has the following issues. The passenger side hinge for the rear upper hatch has broken away from the upper support. This will require the metal to be welded back in place. There is also evidence of a repair on the drivers side cowl area. It looks like it was hit in the side, just in front of the door. There is bondo up to 1/4 inch thick in this area. The doors appear to be solid and there is no evidence of rust through. Some of the interior handles are missing and the front door latches are not holding the doors closed. The parts appear to be all there but need adjusting of refurbishing. The glass is all there and is in good condition. Headliner is deteriorated but the bows are intact. This is a good candidate for a restoration. There were very few of these imported in the US and according to some websites, less than 100 are known to exist. The vehicle is available for inspection in Sheridan Wyoming. Please ask any questions before placing a bid. This cruiser comes with a clear Wyoming title. I have it in my hand. On Apr-03-14 at 06:22:52 PDT, seller added the following information: This rig comes with an extra hood that is correct for an FJ45LV and spare Rochester carb, The vehicle can be stored for up to 60 days as long as full payment has been received. It is currently loaded on a car hauler and I can meet your shipper at a convenient location for loading in the sheridan area.