Detail Info for: International Harvester : Other Pickup 1952 International Pickup Truck

Transaction Info
Sold On:
04/23/2013
Price:
$ 6200.00
Condition:
Mileage:
933
Location:
Port Charlotte, Florida, 33948
Seller Type:
Private Seller
Vehicle Specification
Year Make Model:
1952 International Harvester Other
Submodel Body Type:
Pickup Truck
Engine:
6 cylinder
Transmission:
Manual
VIN:
Vehicle Title:
Clear
Drive Train:
Fuel Type:
Gas
Standard Equipment:
Optional Equipment:
Vehicle Detail
****HEALTH REASONS FORCES ME TO SELL MY PROJECT***** My loss, your gain. I have over $11,000.00 invested in this truck. I bought this 1952 International L-120 in Rapid City, South Dakota and had it shipped to Florida to rebuild. Unfortunually my health has declined and I am unable to finish it. The story I was told by the gentleman I bought it from was that his father bought this truck brand new to use around the ranch. The headgasket blew around 1957 and they didn't have the money to repair it, so his father stuck it in the barn where it sat until June 2012, I bought it in July 2012. This truck only has 933 origional miles on it. I have completly redone the interior, recovered the seat, new international floor cab mat, replaced the drivers door, passenger door, and rear windows with tinted glass (photos). I was in the process of re-wiring the dash to convert from 6 to 12 volt (photo). It has new brakes, new front wheel cylinders, rebuilt rear wheel cylinders (photos), all 4 drums have been turned, new master cylinder. Door seals have been replaced, everything has been bought to complete this truck. New head lights, tail lights, hood seals, cowl vent seal, new pressure plate, T.O. bearing, bell housing, starter for ford 6 cylinder, everything is in the cab. Truck cab corners are soild (photos). The motor I was planning on putting in this vehicle is a 1981 Ford 300 6 cylinder. I have completly rebuilt it (photo), and it is ready to go. It has a new oil pump, head has been machined and valve job completed. New intake, exhaust manifold, new carb, new alt, waterpump etc.. i also have a 1967 mustang 3 speed transmission that I was going to install. You can either manufacture linkage to us the tree or cut a hole in the floor and put the shifter on the floor. I was going to manufacture the linkage to use the tree. Like I said, this project has everything to complete it! My health is keeping me from doing it. I will help load the vehicle to transport, buyer just needs to arrange it. Vehicle rolls and has brakes. I took the drums off to show that it did have new brakes. Whoever wins this will have a very nice truck with very little cost out of their pocket to complete. Good luck and happy bidding! Deposit of $1000.00 through paypal required after auction end, thanks! On Apr-16-13 at 06:57:33 PDT, seller added the following information: SAVE MONEY ON SHIPPING! uShip is the first and largest auction style marketplace for shipping and transportation services.Learn More SHIPPING PRICE ESTIMATOR Delivery ZIP Code: MORE RESOURCES: uShip Guides and Articles uShip Provider Directory Other Useful Tools & Links