1991 Honda Civic

Hatchback

D16A VTEC

Manual

2HGED7361MH580106

Clear

Gasoline

1991 HONDA CIVIC SI LOW RESERVE!3-DOOR HATCHBACKWHAT AN OLD SCHOOL FINDTHIS SI IS A TRUE SOUTHERN CAR D16A VTEC JDM ENGINE SWAP~RELISTED DUE TO MISUNDERSTANDINGNO FREE SHIPPING,SHIPPING IS RESPONSIBILITY OF PURCHASER!Posi unitCar shows well, small dings and paint chips here and there~oxidation on roof~NEW~BRAKES~KUMHO 205/50/15 tires ~DC Header~ Auto Tecnica Steering Wheel~Clarion DRX9255 HU~ADS 430x~Alpine 3503~ McIntosh 10" Sub~Eclipse 6" and 1" door tweeters~Jackson Racing Supercharger with 6lb pulley~Upgraded Fuel pump and injectors~P28 Chipped PCM~SPEC Stage 3 Clutch and SPEC Lightweight Aluminium Flywheel just installed~Tires are like new~brakes just done~ CAR GETS LOOKS AND TURNS HEADS EVERYWHERE On Jul-06-14 at 11:03:03 PDT, seller added the following information: Previous Purchaser thought there was FREE SHIPPING....THERE IS NO FREE SHIPPING, SHIPPING IS THE RESPONSIBILITY OF THE BUYER.. IF YOU ARE PURCHASING FOR SOMEONE ELSE YOU HANDLE THE SHIPPING TO THEM ...NOT ME...I am selling because I have too many vehicles ...the engine is a JDM swap with an estimated 65000 miles...28-30 mpg if you keep your foot out of it..maybe better...too fun to drive it slow...it does not burn oil and does not smoke or knock...the only thing I would do to it is charge the a/c system and fix the rubber molding around the windshield where the blue tape is in the picture...the engine is a d16a VTEC with 175-180 HP to the wheels...I have dyno sheet done at jmills tuning 2,weeks ago on a extremely hot day and it put 170 to the wheels...meaning the engine has approximately 200+ HP at the flywheel...the transmission is solid and is positive traction...to build this car minus stereo and cost of car would be around 6500-7500...very solid car with no rust and just oxidized paint on top that should wax out...interior is very clean to be 23 years old...tires are like new and brakes were just done with new rotors and pads...Tires are like new~brakes just done,DC header,SPEC Stage 3 Clutch and SPEC Lightweight Aluminium Flywheel just installed... brospeed exhaust...really too much to list