1966 Chevrolet C-10

Shortbed Pickup Truck

350 Chevy

Automatic

C1446S199217

Clear

Gasoline

I am selling my 1966 C10. It has had tons of new parts added to it in the last 5 months. Lots of time and energy went into it to make it a nice cruiser. Below is a list of parts that are on it and that have been reworked or replaced:From the front of the truck back:New front ball joints, upper and lowerNew tie rod ends, inner, outer and adjustment sleevesNew 2" lowering springs from CPPNew shocksNew brake lines from master cylinder to drums on front, rear is still stock for nowEngine is a healthy 350 with a 292 camshaft with headers and new gaskets along with new exhaust including a X-pipe with removable cutoutsAluminum radiator with new hosesNew low temp thermostat, runs 170 driving and 180-190 sitting in trafficNew battery and cablesNew battery trayNew oil pan gasket, carb gasket, thermostat gasket, valve cover gaskets, PCV valveNew Edelbrock 600 cfm carburatorNew fuel pump, line and filter to carbNew distributor, spark plugs, and wiresNew Electric cooling fanRebuilt alternator charging at 14.5 voltsNew heater hose linesEngine bay has been refinishedNew wiring harness including plugs and sockets from headlights to taillightsNew windshield and gasketNew window regulators, seals, 1/4 seal, and inside door handlesNew gauges for volt, fuel water and oil pressure New paint on dashNew custom made switch gear along with relocation of factory switchesShortened steering column for comfortB&M floor shifterNew vinyl seat upholsteryNew dynamat over spray sound deadener under new carpetNew rear window gasketNew bed wood along with strips and boltsNew 3" rear lowering springs and hold downsNew LED tail lights and reverse light lensesNew LED tailgate light barTruck sits on not very old McClean 15" spoke wheels with a deep dish and two brand new tires, other two have good tread life leftEvery bolt that was removed went back new, hardly any hardware was reused in this truckI know I am forgetting some stuff but this truck is awesome. Still needs some attention to the body work but is a very nice truck. I have over 200 hours in it within the past few months. Truck was shown at Blue Suede Cruise in Tupelo, MS and got tons attention. Can help arrange shipment if needed or if within 200 miles personally deliver.