1997 Eagle Talon

Hatchback

2.0L 1997CC 122Cu. In. l4 GAS DOHC Turbocharged

4e3al54f0ve067997

Clear

GAS

Its that time!! I have to get rid of one of my favorite toys... 97 Eagle Talon AWD. The mods list is as follows:: Evo 8 ecu -- Tactrix 1.3 -- Evo 8 brembos with slotted rotors , steel braided brake lines, JDM knuckles for mounting the brembos -- steel braided clutch line -- steel braided turbo feed -- abs delete prop valve-- 3g booster -- 3g master -- Evo 8 recaros -- Sparco harness -- Haarness bar -- Evo 8 hids (not installed) -- Evo 8 knob -- Evo 8 mats -- Evo 8 fmic -- Evo 8 maf -- 18" axis super hiro rims – gunmetal – with good tires (1 tire has excessive wear) -- I forgot which one, but front and rear camber kit -- Fuelab afpr (~100 miles) with gauge and install kit -- Sportlines on KYB adj -- CF hood oem style with 2 vents -- Innovative mtx wideband (~100 miles) -- Autometer carbon boost/oil gauges -- Ebay short shifter -- Hallman mbc (~100 miles) - Battery relocated to the rear with 0 ga wire, drycell battery (comes with all wires needed to run to the starter and fuse box, the circuit breaker, and dist box) -- Cruise delete / noncruise cable -- Ported Hafe exhaust manifold with 38mm wg port -- Stock t25, normal play, great condition – best offer Apexi n1 with custom apexi dp w/ magnaflow 3" cat welded -- Front and rear sway bars (engine bay and under the vehicle) stock trans and 7bolt with ~170 miles on the new head, new HG, arp studs, and all new timing components -- ~~~~~~~~~~The following items are UNINSTALLED and will be additional if you would like them~~~~~~ Twisty side skirts -- uninstalled Rc 750s (~20 miles) -- uninstalled currently 0 miles, mhi evo316g rebuilt by Justin -- never installed Evo3 o2 housing -- never installed Fuelab fuel filter 818 with install kit (0 miles) -- uninstalled Walbro 255 with o-ring for the pump seal -- uninstalled Emusa 38mm wg (0 miles) -- uninstalled 300c COP setup with plate and 6 (yes 6) coils, ready to pop in your car-- uninstalled Complete front suspension package (all control arms, inner and outer tie rods, swaybar links) -- new in box This car is ready to go!!! Unfortunately (lol) were expecting a new child so see ya to all my toys! :-( --- If you have an offer then please message me! Thanks! On May-24-14 at 15:06:04 PDT, seller added the following information: I didn't mention it had a new xtd 6 puck unsprung clutch and clutchmasters flywheel (300 miles). The camber kit is eibach, and the front and rear stabilizer bars are suspension technique. When I rebuilt the head I replaced the rod bearings and the piston rings as well. As of ~a month ago the compression was ~180 across the board (again, ive only driven it 300 miles since then). Everything is good and it runs great. Only issue is there is a small boost leak from one of the couplers connecting the front mount to the hard piping which causes a small stutter at WOT/10psi + ... Theres a suspension squeak from the front end, but the kit I have listed (control arms, etc -- ) will fix that. I just never had time to install either fix due to my current situation.