1970 Dodge Dart

Swinger Coupe

none

Automatic

ll23c0r194707

Clear

This is a project that I started and cannot finish. It has had a lot of good work done to the body. The trunk floor and interior floor have been replaced. Most of the bodywork is done and primed. It comes with a good 904 automatic transmission. Front and rear glass are good. The seats have all been freshly reupholstered tuck-and-roll black. I can send you the list and cost of all of the repairs done to date, if you are serious about the car. Plus all the pictures. It is rolling and packed up with everything, ready for pick-up. Relisted due to non-payment. Please pay for it if you buy it. On Apr-18-14 at 07:46:48 PDT, seller added the following information: The body panels have been reassembled and all of the parts are in the car. The tires hold air just fine. A shipper can just load it right up, with a winch. On Apr-21-14 at 08:31:49 PDT, seller added the following information: List of work performed to date: Day Date Hours -Disc. Of work done $ per hr Amount Mon 11/19/2012 5.5 -Prep fenders and driver’s door for self-etch, $ 40.00 $ 220.00 remove windows both doors. Tue 11/20/2012 8 -Prep Pass door & trunk lid. Spray self-etch primer $ 40.00 $ 320.00 on fenders doors and trunk. Stud gun pass door dents and float in, make body lines. Dolly out crease in bottom of door, start working drivers Dr. Wed 11/21/2012 8 -Finish driver’s door and fender, cut out part of pass. $ 40.00 $ 320.00 fender and replace metal, grind out other dings in fender. Fri 11/23/2012 6 -Finish Pass. Fender and repair dents in trunk lid. $ 50.00 $ 300.00 Prime fender ext. doors and fenders W/ self-etch. Mon 11/26/2012 7.5 -Cut out rust spots in front of hood and weld in $ 50.00 $ 375.00 new metal. Sand down hood, grind down welds and prime W/ self-etch primer. Tue 11/27/2012 4 -Drill out spot welds around floor pan and remove $ 50.00 $ 200.00 surrounding metal. Yrs 11/29/2012 5.5 -Finish removal of floor pan and remove trunk floor $ 50.00 $ 275.00 Mon 12/10/2012 2.5 -Worked on trunk floor, Fab new piece for floor to $ 50.00 $ 125.00 weld to. Grind spot welds. Tue 12/11/2012 2 -work on trunk install, cut grind. $ 50.00 $ 100.00 Wed 12-Dec 7.5 -Weld in new metal on bottom brace for trunk pan. $ 50.00 $ 375.00 fab new metal for edges of trunk pan and weld in. straighten rear part of car to meet trunk pan. Weld trunk pan in place. Grind inside of walls to weld in floor pan. Trs 12/13/2012 6 -Grind down and weld in floor pan, seam seal $ 50.00 $ 300.00 Fri 12/14/2012 2.5 -Complete floor install, seam seal all joints, and $ 50.00 $ 125.00 clean up. Tue 4/9/2013 2 -Assemble fenders, hood, doors, and trunk on car. $ 50.00 $ 100.00 Normal 0 false false false EN-US X-NONE X-NONE