1974 Dodge Challenger

500 CID Stroker 2 owner Coupe

500 CID

Automatic

JH23G4b28xxxx

Clear

Gasoline

1974 Dodge Challenger Rally Stroker project. Original 24,000 mile 318 car with 500 CID stroker 550 horsepower pump gas street motor. Before me, this car was owned by 1 family. EXTERIOR: The body is all original panels with the exception of the trunk floor and rear quarter patch panels and extensions. Original floor pans are excellent and underside is in wonderful condition. Needs body work and paint. It has been stored indoors most of its life and in a heated garage last 6 years. I was planning on painting it black and the engine compartment has been painted allready. Rally hood. Have all exterior trim and some pieces are NOS. 2 front fiberglass header panels. Grill (2) are mint also excellent bumper filler pieces. Excellent original bumpers both front and rear. Valances are in great condition. Glass is all good but may be missing 1 of the door glasses. Rear light lenses are excellent. Has a go wing and another trunk lid is included in auction. The trunk lid is 100% rust free and nice. Both front fenders and hood are good but do show somwe rust. INTERIOR: Very very nice. Rally dash is in excellent condition, NO CRACKS. all ready to go. The guages are in excellent condition. The needles were painted to brighten them up and the lens polished. All plastic is pretty much perfect. I have had a number of challengers and this car was being built for myself. If there was a flaw, it was replaced, so the console, door panels, rear sail panels and all the dash parts are nice. Locks rechromed. Visors perfect and rearview mirror detailed. I am including some overhead console parts as I was going to install one and a rear defogger motor.(N/A 1974) Brake and gas pedals have been painted and detailed. Factory AM radio is excellent as the knobs. You will need to buy carpet and headliner other than that nothing else appears missing. All the window crank handles have excellent chrome. Other than that the interior should be done. The seats are in excellent original condition. They are soft, clean, and ready to use. Some imperfections on the driverside seat (minor) but nothing needs replaced. Also the 3 spoke steering wheel in picture has been replaced with the excellent original 2 spoke. DRIVELINE: This Auction includes 2 fresh unfired engines. The 493 cost approx 8500.00 ALONE! The numbers matching original 318 I had gone through. The machinest said he had no problem believing the motor only had 24k. Anyways I had him go through and put bearings rings etc. and rebuild the motor to stock specs so if a guy wanted to redo the car to stock specs, that one is fresh, 230 horsepower and ready to go. The motor I planned on putting in it is a 1970 440 now a 493 CID stroker motor. Complete long block. Intake to pan. Built by reputable speed shop. I have the build sheet. It should produce over 500 ft/lb torque and around 550 horsepower give or take 10%. Edelbrock ALUMINUM heads, roller rockers, etc etc etc. NO corners cut. Built to run on pump gas, sit in traffic and actually use during the week but be able to run 11 second quarter miles on the weekend. I have over 8000.00 in motor alone. Transmission was rebuilt and I used it in a 1969 Coronet R/T 440 6 pack. Has very little use. manual valve body, reverse pattern, shift kit etc. Expensive Hi stall converter. Also have the original numbers tranny (I think iots a 904) Comes with 2 -8 3/4 rear ends. The stock one and I was putting reinforced a body (narrower) with hanger relocation kit. Rear axle is beautiful painted heavy on the glitter! 3 inch studs, green bearings etc. 355 posi, 489 case. Also New leaf springs. I could write for hours and hours. SERIOUS BUYERS ALLWAYS CALL. Please do. I will answer any questions you may have. There are many parts that go with the car that were not ness to its restoration but my garage is losing all E body stuff I have. There is another set of seats, a dash, a complete front suspension. I am hoping to sell this car to someone going the resto mod route that can use everything sell whats extra or build another.If the car does not bring what I need to sell I will be listing the car as a stock project and seperateing the 500, and tranny as that is a large chunk of the pie. Also I am including multipule wiring harnesses. Think of it like one of those models you had when you were a kid. the kit came with both stock and Hi-per versions. You decide!! I have had 450 transactions on ebay and 1 bad buyer that has affected my feedback. It is bound to happen sooner or later but I want to reassure buyer. I have had 100% positive feedback for 10 years. I will assist any way I can in shipping. I will sell car less motor (500) and trans (727) for 8900.00On Jul-21-13 at 11:27:41 PDT, seller added the following information: There was a hole cut in floor where previous owner wanted to install a 4 speed. I have the patch to fix. The car is rock solid. Never any rust around windows or anything. Also there has been no bodywork done underneath the primer that it is masking. There is some pitting along the bottom edge of front fenders and some repair will be needed on the inside were it bolts on under hood shown in last pict.On Jul-23-13 at 12:52:02 PDT, seller added the following information: PHONE NUMBER TO CALL IS 651-354-7215 not 612 Thank you.