1992 Ford Mustang

Hatchback

8 Cylinder

Manual

1facp42e3nf171327

Gasoline

Rear Spoiler

1992 Mustang GT rolling big block project. Selling as is, not time to complete. Body is a 76000 mile Arizona rust free never damaged car. Paint has been redone and is very good. The interior is stripped and ready for a cage and guages. This is a great project with unbelievable potential. Completed, these things are pretty valuable and blindingly faster than any small block. What's done; body, new Eibach springs, Flaming River steering, motor (not installed). What it needs: Transmission, fuel, spark, water, wheels and tires. The motor: A basically stock 1971 429 .60 over high compression with forged pistons, sized rods, hardened rod bolts, medium Competition Cam, line bored, balanced crank heavy valve springs, custom Milodon 12 quart pan, and Edelbrock 460 Performer manifold. Machined and assembled professionally by Bailey's of Mesa, estimated at 400 horsepower. The motor has about 500 easy miles on it. Parts that go with it: clutch, mufflers, Mallory Unilite distributor, racing bellhousing, headers, and a lot more. To make this work with the 429 you will need to purchase a special oil pan, headers, and bell housing to tie up to a T5 transmission. Total cost for all that is about $1000 plus another $1200 for the transmission. I have all the correct part numbers that you will need. Since I don't have the time to complete, you will also get my new engine hoist, and engine stand to go with it. Pick up only. I have four wheels and messed up tires which can be used to roll it on your trailer.