Detail Info for: 1975 Suzuki TM-250

Transaction Info
Sold On:
05/16/2010
Price:
$ 610.00
Condition:
Used
Mileage:
500
Location:
elmira, OR, 97437
Seller Type:
Private seller
Vehicle Specification
Year Make Model:
1975 Suzuki RM
Submodel Body Type:
Engine:
Transmission:
VIN:
Vehicle Title:
Other
Drive Train:
Fuel Type:
Standard Equipment:
Optional Equipment:
Vehicle Detail
This is a pretty nice old TM 250 that was sitting behind my neighbors garage, I cleaned the carburator, put a new spark plug in it and a new air filter and it fired right up. It runs great, has lots of power. Shifts through all 5 gears fine and the clutch does not slip. It has Preston Petty "MUDER" fenders front and rear that were white and somebody painted them yellow. The exhaust pipe is not original, it has been modified, a little bit weird and ugly but works very well. Apparently while it was sitting for the last couple of years somebody robbed the oil injector tank and side plate off of it. The actual injector pump itself is still intact so I put screws in both holes where injector lines go on and then mixed up some premix to make sure it ran and shifted thru all the gears fine. The seat is in nice shape. The gas tank has a few small dents in it which may not be visible in the pics because they are that small. Tires hold air and are in decent shape. Brakes work. Could definitely use some correct hardware here and there. However it is ready to load up and go riding. If you have any questions email me or call Dave at: 541-935-3067. Item must be paid in full within 7 days of auction close. Buyer is responsible for transportation. Thanks for looking and happy bidding!! THIS IS A NO RESERVE AUCTION keywords: vintage motocrosser, vintage dirtbike,Suzuki, TM, FIMOn May-10-10 at 18:16:06 PDT, seller added the following information: I did not get a title with the bike so all I can offer is a Bill Of Sale.On May-10-10 at 20:41:18 PDT, seller added the following information: On a side note: Running this engine with no oil injecter will starve the ignition side main bearing of oil.Because it has a shield on the inside to retain injecter oil.You can remove the shield and run pre-mix with no problem.