1975 Ford Bronco

SUV

302 V8

Manual

Clear

Gasoline

Up for sale is my 1975 Ford bronco. It runs well and drove around town on occasion and even participated in a few cruises during Bronco Super Celebration in Tennessee last last. It has been garage kept by me, I believe I am only the 3rd owner based on history from the guy I purchased it from 3 years ago. As you can see in the photos, I was slowly rebuilding her back to like new and stock. I have lots of new parts for her, around 2k worth. See list below: Eaton trutrac 4:11Chrome moly axles /with bearings already installed from factory (came from wild horse)Ring and pinionFor 9” rebuild kit Rear brake cylinders Dane 20 rebuild kitBody bushingsPassenger side A door postPassenger side inner panel interior Passenger and driver side rocker panelsPassenger and driver side inner fender panelsJames Duff hood strut systemRear leaf spring brackets Parts already replaced:RadiatorDouble roller timing chainWater pumpFuel pumpAuxiliary and rear main tankFuel tank selection Fuel sending unitsFuel line from rear to frontMtorocraft 2bl CarbValve cover gasketsHeadlightHeadlight relays to stop know issue with blinking on and offGasket kit for hard topNew tires This is a solid bronco that would take much to finish it off with parts I have. It’s all bone stock with no modifications done to it at this time except bench seat. As you can see from pics, I have original seats. Front is a Dana 44Rear is ford 9” with factory 411 gears3sp RAT on the columnDana 20 transfer As you can see from the pic, the only body rustissues are the passenger side A post, inner panel, hole in floor on passenger side floor, but the rest is not too bad for a 75 vehicle. Would recommend a complete new floor if doing full restoration (that was my plan). Inner Fender rust as seen on many of these and both rocker panels. But, like I said above, I have all pieces to go with it. Buyer takes all things bronco that I have!! Vin# and more pics and even a video of motor running available upon request. Post limited me. Thanks for looking