1980 Jeep Other

Pickup Truck

360

Manual

J0M46YN042295

Clear

Gasoline

Here is a 1980 Jeep J20 pickup with a AMC 360 V8 that was rebuilt 700 miles ago. Rebuild was done by a shop the rebuilds AMC engines to the orginal 4 barrel performance level. The motor was built to 235 HP and then I had an Elderbrock performer intake installed, Hooker super competition headers, and Holley projection EFI. Many parts on motor were powder coated also. A new heavy duty clutch was installed with rebuilt motor. I also had a rough country 4" lift kit installed. There is a 7 pin trailer brake system installed as well. Mechanically This truck is very sound, I had all fluids changed when I bought it, as well as greasable ujoints, ball joints installed,front wheel bearings repacked, new rear brakes, etc.The frame is solid with no holes, but the body has rust at all of the corners with holes at most corners as well. The drivers door knob does not stay up and will lock when closed. The speedometer sticks at 47 MPH until it gets to around 60Mph then works fine. If it is driven for awhile it has gone away. This went away for awhile then came back after sitting 6 monthes. Grand Wagoneer power seats were install when I bought this truck and they are wired up and work good. Floor is carpeted. Headliner is missing the cloth as it fell down years ago. I am listing this truck locally, and inspections, and test drives are welcome. I am also including a AMC brush guard, and light bar for the bed, that are not currently installed as well as some 33" mud tires on 15" rims. I also have misc jeep parts that I have collected over the years to go with the new buyer.