1984 GMC

Pickup truck

5.0L 8 Cylinder Gasoline Fuel

Automatic

2GTDC14H7E1500084

Clear

Gasoline

You are looking at a 1984 1500 GMC Pick- up 6' bed fleetside. Vin# 2GTDC14H7E1500084 . It was a 305 V 8 with 700 R4 trans, power steering , disc brakes, factory AC. I've owned this truck 2 times. I drove it for for about a year as a shop truck and parts chaser. Then I installed a GM Crate 350 engine and turbo 350 trans. I had a new drive shaft made for the swap. I drove it for about a year then I sold it to a friend and customer of mine that needed a truck. He drove it for about 2 years then I bought it back again. I am getting laid off my job and cannot afford to finish the truck. I have put a LOT of time, money and effort into this truck. Whats been done: Frame: taken down to bare frame, sandblasted, painted with 2 coats black epoxy primer & 3 coats eastwood frame apint. Front suspension: all new moog parts, upper and lower A- arm bushings, new upper and lower ball joints, new tie rod ends, new center link, new idler arm, shocks, wheel bearings and seals and new poly motor frame mounts. Rear suspension: 12 bolt H .D axel, new poly spring bushings, new shocks, 3 new parking brake cables, Wagner. All new wagner brake hardware. new wheel cylinders, axel bearings and seals. New chrome rear cover , new 31 gallon fuel tank. fuel lines and inline filter. All new stainless steel brake lines. new front and rear brake hoses, new wagner master cylinder. Bed: Stripped down to bare metal, 2 new bed sides,this bed is in super solid shape, no rust or rot, bottom of bed floor is bed liner coated black. Wheel tubs and front of bed are in excellent shape. Tailgate has a couple dent's not that bad and there is no rust. Cab: Is in excellent shape it had 1 small rust hole the size of a dime in cab corner. Was also stripped to bare metal has 2 coats of black expoxy paint, 3 coats of Urethane primer. bottom of cab also painter in bed liner. All new cab, bed, and front end body mounts and hardware kit. New GM dash pad, new A/C heate control assembly, new heater core, new a/c vent assembly. Floor and firewall done in dyna-mat. Front end: hood stripped to bare metal, 2 coats epoxy primer, 3 coats urethane primer, no rust or rot. Fenders: stripped to bare metal, no rust or rot , 2 coats of epoxy primer. couple small dents very solid. Front grille and headlights from "89" blazer sand blasted epoxy primer and eastwood paint. 2 new front inner fender wells, bedliner on outside and epoxy on inside. I have all good tinted glass for truck. Also stock chrome bumpers and brackets. I have 4 15 X 8 Truck rally rims. On Aug-16-11 at 19:07:14 PDT, seller added the following information: This project truck does not come with the 350 engine and transmission. Just want to make sure everyone knows this. Sorry for any mixup.