1986 Dodge

Daytona

4 - Cyl.

Manual

1B3BA64E6GG252899

Gasoline

1986 Dodge Daytona Carroll Shellby Turbo Z Turbo I, 5-Speed One owner Car Never Driven in the Winter Only Rust on Car Would be Surface ...Around the Emergency Brake Cable "NO RUST" In Rockers ...Fender Wells.... Rear Quarters....Floor Pan Always Stored in a Shed Through the Winter Clear Coat in Great Condition Odometer Has Turned Over to 6900 There Are a Few Door Dings Door Bushings and Pins are Tight...Doors Close Tight Car Goes Down the Road Straight with Very Little Noise On a Spring Day the Car Got Caught in a Light Hail Storm There Are a Few Light Hail Dents in Roof and Hood Also the Hood Has a Wrinkle in the Right Front Edge From Being Backed Into Seats Are Cloth Interior in Good Condition (Front and Rear Seats Also Carpet) Head Liner is Starting to Seperate Engine was Removed ,Totally Disassembled and Re-Built ...Including- Hone Cylinders, Clean all Parts Grind Valve Seats and Valves check Valve Guides Check Head for Warpage -.0015 (Service Manual Allows up to .004) Engine Was Assembled Using These Items 4621120 Mopar Turbo Feed Line 3848361 Mopar Hose to Back of Water Pump from Heater Valve 3849303 Mopar Preformed Heater Hose From Turbo to Water Valve Federal Mogul Rod Mains,Rings and Intermediate Shaft Bushings Mopar Performance "005" Head Gasket Mopar Cam Plug and Crank/Cam/Intermediate Seals Replaced All Hose Clamps, Heater Hoses and Radiator Hoses New Fel Pro Head Bolts (Torqued to 65 Plus 1/4 Turn....Making the 90 lbs Min Torque) Intake/Exhaust Gasket Oil Pan End Gaskets Valve Cover End Gaskets Rear Main Seal Brass Soft Plugs Tube of RTV New Timing Belt and Tightener Water Pump, A/C and P/S Belts and A/C Tightener Stant Super Stat New Water Pump Wix Fuel Filter LUK 05-002 Clutch Kit with Throw Out Bearing New Exhaust Flange Spring and Bolt Kit New Fuel Line for Filter and to Injector Rail Quart of Brake Fluid 1-1/2 Gal. Anti-Freeze A/C Hose Assembly Dryer and Gaskets 3- Cans 134 Tires Are Low Mileage so are Brakes and Exhaust Bleed out all the old Fluid Re-Packed Rear Wheel Bearings Pulled Sway Bar Out and Sprayed Silicone Lube on Rubber Grommets to Loosen