1968 Dodge Charger

Hardtop

6.3L 6286CC 383Cu. In. V8 GAS OHV Naturally Aspira

Automatic

XP29H88B163012

Clear

GAS

1968 Charger 383 automatic, power window car, A/C,I have this car in bare metal so you'll know exactly what you're buying beforehand. Rust and major damage has been repaired, and is ready for filler, primer and paint. Please contact me prior to delivery about epoxy priming the vehicle if you feel it is necessary. There is low mileage on the rebuilds of both the transmission and the engine. Runs, but the old dual point Mallory distributor needs points, and a tune up. The engine sounds very strong, and I can tell it has a mild cam in it. What I've tried to accomplish here, is to do all the work that the average car enthusiast doesn't know how to do - ie: sheet metal work, and let you take it from there. If you want me to take the car even further, I am certainly capable of any level of restoration that you desire. I can provide examples of past vehicles for your review.The right side quarter panel was replaced, by me, in a sympathetic manner. I don’t butcher sheet metal work! Every effort was taken to minimize distortion, maximize OEM appearance, and quality. I also replaced the panel below the rear bumper, and each corner piece. The left side quarter panel only needed small rust patches. The floor and subframe are in perfect condition, except for one patch I made in the driver’s side foot well. Prior to my ownership, the trunk floor had been replaced. The quality of the installation of the trunk floor is not as good as the metal work I did, but it is good enough for a driver. If you want me to replace the trunk floor in an OEM fashion the way the rest of the sheet metal is done, contact me for pricing. I don’t mind doing it before the car is delivered. Fender tag and build sheet are not with the car. I have spoken with a previous owner, and he put them in a “safe place” and can’t remember where they are. It is an original 383 VIN, and was quite obviously an A/C and power window car. I do have the history of 3 previous owners of the car if it is important to you. The car is mostly complete. A few boxes of parts, one extra door, and one extra deck lid come with the car. However, essentially, what you see is what you get. I have no keys for it, so you'll need a locksmith to make a set for it. Car comes with clear Utah title. . Quarter panel seam work Passenger’s side rear footwell Passenger’s side front footwell (surface rust only) Driver’s side front footwell – 1 small patch required only. Driver’s side rear footwell Driver’s side front subframe (note footwell patch above) Passenger’s front subframe Lower rear bumper area has been replaced, as well as the corners Small patches in original driver’s side quarter panel Previous to my ownership, a new trunk floor was installed Inside passenger’s side quarter area, one small patch was hand formed to replicate OEM Inside passenger’s quarter panel area, POR 15 applied, and weld-thru primer used at spot weld areas OEM style spot welds used for installation of quarter panel, rather than plug welding On Aug-03-14 at 16:33:08 PDT, seller added the following information: IF YOU ARE A BIDDER WITH NO FEEDBACK, OR A NEW ACCOUNT, CONTACT ME PRIOR TO BIDDING OR YOUR BID WILL BE CANCELLED.