1973 Saab Other

Coupe

V4

Manual

97735001098

Clear

Gasoline

1973 SAAB SONETT 3 UP FOR SALE IS MY 1973 SAAB SONETT 3 !!! IT HAS THE FORD V4 ENGINE, 4 SPD TRANS WITH NEWER PRESSURE PLATE/DISC AND THROW OUT BEARING. THE FRAME IS SOLID WITH NO RUST OR ROT AT ALL!!! THE FOLLOWING IS A LIST OF REPAIRS/UPGRADES THAT HAVE RECENTLY BEEN PERFORMED ( 6/2011 - 12/2013 ): 1. PREVIOUS OWNER RAN A BODY/FRAME REPAIR SHOP FOR 35 YEARS, BEFORE RETIRING THIS WAS HIS LAST PROJECT. THE FRAME WAS REBUILT TO SPEC AND POWDERCOATED IN 1999, SHORTLY AFTER HE BECAME ILL AND IT WAS STORED IN THE SHOP UNTIL I BOUGHT IT IN 2011. THE FRAME LOOKS AMAZING, HIS SON STATED A FRAME REBUILD OF THAT QUALITY WOULD COST BETWEEN $6,000 - $8000. 2. 4 BRAND NEW BRIDGESTONE ECOPIA 175/65/15 65,000 MILE TIRES WERE MOUNTED AND BALANCED THEN INSTALLED IN SPRING 2013 ($585 TOTAL COST) 3. COMPLETE ENGINE TUNE UP ( CAP, ROTOR, PLUGS, WIRES, AIR FILTERS, FUEL FILTER, THERMOSTAT) WITH THE PERTRONIX ELECTRONIC IGNITION CONVERSION AND 40,000 VOLT COIL INSTALLED 4. COMPLETE REBUILD OF THE REAR END ( KYB SHOCKS, BUSHINGS, BRAKE LINES, SHOES, HARDWARE KIT, WHEEL BEARINGS/SEALS, BRAKE WHEEL CYLINDER) 5. BATTERY HAS BEEN RELOCATED TO THE TRUNK WITH BRAND NEW POSITIVE AND GROUND CABLES THE CAR STILL NEEDS THE BRAKE AND CLUTCH MASTER CYLINDERS INSTALLED ( I HAVE NOS REPLACEMENTS OF BOTH) AS OF 12/11, BUT IM PLANNING ON REPLACING BOTH MYSELF BEFORE AUCTIONS END, AND I HAVE ALL THE NEW FRONT END PIECES (TIE RODS, BALL JOINTS, SHOCKS, BRAKE PADS, BRAKE LINES AND BEARINGS/SEALS) TO INCLUDE WITH THE CAR. I WILL HAVE MORE PICS UP ON 12/12 OF THE REST OF THE CAR NOT SHOWN. CAR IS LOCATED IN THE CLEVELAND OHIO AREA, IF THE CAR IS FULLY PAID THROUGH PAYPAL I CAN STORE AT MY HOME UNTIL TRANSPORTATION ARRANGEMENTS ARE MADE, UNTIL SPRING COMES FOR THOSE INTERESTED ON THE WEST COAST OR WE CAN MAKE DELIVERY ARRANGEMENTS FOR AN ADDITION FEE.