1970 Ford Bronco

289 v8

Manual

xxxxxxxxxxxxxxxx

Clear

Gasoline

1970 bronco straight body ready for paint after wet sanding, lots of new parts to put back together such as gaskets , mirrors ect , have both bumpers they are the tube type w/ brush guards will send pictures later, truck has 389 w/ 3speed on the floor new transfer case and transmission new engine and clutch, 3 inch lift kit, fender flaires included when this truck is dressed out with bumpers and flaires it looks awesome of course they are removed for preparation for paint. i have a complete danna 44 front disc axle that goes with it . now i will list the main problem which is not so bad. the engine was rebuilt about 3 weeks ago i only rebuilt the motor because it use to smoke a little but it ran fine and drove really good now after it was rebuilt it ran even better but when i pushed in the clutch i heard a scrubbing noise , come to find out the crank shaft was moving foreward in the block causing the flywheel to scrub against the engine spacer plate.now any good mechanic will tell you there is only one culprit responsible for that and that is the thrust bearing now when i was putting in the bearings something just didnt feel right abut the thrust bearing but i put it in anyways so anyways the thrust bearing was the wrong size, this is a easy fix because the truck is lifted giving me a mile of space to drop the oil pan and install the proper thrust bearing. that is the only problem that needs to be addressed you can call me at #662 397 3242